Installation Guide
Table Of Contents
- SAR-Hm and SAR-Hmc Chassis Installation Guide
- Table of Contents
- List of Tables
- List of Figures
- 1 Preface
- 2 Mandatory Regulations
- 2.1 In This Chapter
- 2.2 List of Terms
- 2.3 Safety Warnings / Avertissements de Sécurité
- 2.4 General Requirements
- 2.5 Safety Approvals
- 2.6 Safety Approval for External DC Sources That Power This Equipment
- 2.7 Canada Regulations
- 2.8 United States Regulations
- 2.9 European Union Regulations
- 2.10 United Kingdom Regulations
- 2.11 Australia/New Zealand Regulations
- 2.12 China Regulations
- 2.13 South Korea Regulations
- 2.14 Japan Regulations
- 2.15 Hazardous Locations
- 3 7705 SAR-Hm and 7705 SAR-Hmc Overview
- 3.1 In This Chapter
- 3.2 Overview of the 7705 SAR-Hm and 7705 SAR-Hmc
- 3.2.1 7705 SAR-Hm and 7705 SAR-Hmc Components
- 3.2.1.1 Chassis Features
- 3.2.1.2 Ethernet Ports
- 3.2.1.3 RSVD Port
- 3.2.1.4 RS-232 Ports
- 3.2.1.5 Console Port
- 3.2.1.6 Alarms Port
- 3.2.1.7 Main and Diversity Antenna Connectors
- 3.2.1.8 GPS Antenna Connector
- 3.2.1.9 WLAN Connector
- 3.2.1.10 Chassis Grounding
- 3.2.1.11 Power Supply Input
- 3.2.1.12 High Voltage Power Supply Unit
- 3.2.1.13 Chassis Temperature Control
- 3.2.1.14 Chassis Mounting Options
- 3.2.1 7705 SAR-Hm and 7705 SAR-Hmc Components
- 3.3 Cellular Components
- 3.4 GNSS Components
- 3.5 WLAN Components
- 3.6 Citizens Broadband Radio Service
- 3.7 ADP-Hm Prerequisites and Pre-staging Considerations
- 3.8 Chassis Installation Process
- Customer Document and Product Support
Mandatory Regulations
28
SAR-Hm and SAR-Hmc Chassis Installation Guide
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3HE 17810 AAAA TQZZA
2.3.1 Ground Connections / Raccordement à la Terre
• The chassis must be correctly connected to earth ground.
Le châssis doit être correctement raccordé à la terre.
• Ground connection on the chassis is mandatory. The gauge of the chassis
ground wire must match or exceed the gauge of the supply conductors.
La mise à la terre du châssis est obligatoire. La section du câble de terre du
châssis doit être au moins égale à celle des conducteurs d’alimentation.
• When wiring the unit, the ground connection must always be made first and
disconnected last.
Lors du câblage de l’unité, le câble de terre doit toujours être raccordé en
premier et déconnecté en dernier.
2.3.2 LASER Transceiver / Émetteur-récepteur LASER
• Class 1 LASER product
Appareil à LASER de classe 1
• Pluggable optic modules are very hot while in use. Touch only the extraction
lever or handle when removing the module. Allow the module to cool before
further handling.
Les modules optiques enfichables sont très chauds lorsqu’ils fonctionnent.
Touchez uniquement le levier ou la poignée d’extraction lorsque vous retirez le
module. Laissez-le refroidir avant de poursuivre la manipulation.
2.3.3 Lightning / Foudre
• Lightning strikes are possible during stormy weather and could result in death or
severe injury. Do not work on antenna installation or on power supply lines or
antenna feeds during stormy weather.
La foudre est possible par temps orageux et peut entraîner la mort ou des
blessures graves. Ne travaillez pas sur l’installation de l’antenne, sur les lignes
d’alimentation électrique ou les alimentations de l’antenne en cas d’orage.
• With AC power ports, an external surge protection device is intended to be used
at the AC input of the router.
Avec les ports d’alimentation AC, un dispositif externe de protection contre les
surtensions est destiné à être utilisé à l’entrée AC du routeur.