Product Guide
Table Of Contents
- G-2426G-A Product Guide
- Legal notice
- Contents
- About this document
- 1 ETSI ONT safety guidelines
- 2 ETSI environmental and CRoHS guidelines
- 3 ANSI ONT safety guidelines
- 4 G-2426G-A unit data sheet
- 4.1 Overview
- 4.2 G-2426G-A part numbers and identification
- 4.3 G-2426G-A general description
- 4.4 G-2426G-A software and installation feature support
- 4.5 G-2426G-A interfaces and interface capacity
- 4.6 G-2426G-A LEDs
- 4.7 G-2426G-A detailed specifications
- 4.8 G-2426G-A GEM ports and T-CONTs
- 4.9 G-2426G-A performance monitoring statistics
- 4.10 G-2426G-A functional blocks
- 4.11 G-2426G-A standards compliance
- 4.12 G-2426G-A special considerations
- 5 Install a G-2426G-A indoor ONT
- 6 Replace a G-2426G-A indoor ONT
- 7 Configure a G-2426G-A indoor ONT
- 7.1 Overview
- GUI configuration
- Viewing device information and connection status
- Network configuration
- 7.14 Overview
- 7.15 Configuring LAN
- 7.16 Configuring LAN IPv6
- 7.17 Configuring WAN
- 7.18 Configuring WAN DHCP
- 7.19 Configuring Wireless 2.4GHz
- 7.20 Configuring Wireless 5GHz
- 7.21 Configuring wireless scheduling
- 7.22 Configuring IP routing
- 7.23 Configuring DNS
- 7.24 Configuring TR-069
- 7.25 Configuring GRE tunnel
- 7.26 Configuring Upstream (US) Classifier
- 7.27 Configuring QoS
- Security configuration
- Configuring the Application
- Maintenance
- 7.44 Overview
- 7.45 Configuring the password
- 7.46 WAN speed test
- 7.47 Speed test history
- 7.48 Configuring LOID
- 7.49 Configuring SLID
- 7.50 Managing the device
- 7.51 Backing up the configuration
- 7.52 Restoring the configuration
- 7.53 Upgrading firmware
- 7.54 Rebooting the device
- 7.55 Resetting to factory defaults
- 7.56 Diagnosing WAN connections
- 7.57 Viewing log files
- RG Troubleshooting Counters
- 8 ONT configuration file over OMCI
Table 7-32 Port Forwarding parameters (continued)
Field Description
Enable Mapping Select this checkbox to enable mapping.
WAN Connection List Select a WAN connection from the list.
Note: Only active devices are shown on this list.
3
Click Add.
END OF STEPS
7.38 Configuring port triggering
1
Click Application→Port Triggering from the left pane in the GPON Home Gateway page. The
Port Triggering page displays.
Configure a G-2426G-A indoor ONT
Configuring the Application
Configuring port triggering
7368 ISAM ONT
Draft Draft
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-XXXXX-AAAA-TCZZA
September 2020
138 Issue 1