User Manual

3-21
Defining zone names
To define zone names:
1 From the AP server’s home page, click Configure.
2 From the Configure page, click the Base Station Configuration link.
3 In the Enter new zones below, comma separated field, type the names of base station
zones. Use commas to separate names.
4 For load balancing purposes, you can enter limits on the amount of traffic that a base
station can handle on both the uplink and downlink. If a CPE tries to register with a base
station when either of the limits are met, the CPE will receive a notice that it should try to
register with another, less busy base station. If no such base station is available, the CPE
registers with the first base station.
• To specify the limit of uplink traffic that a base station can handle before the base
stations indicates to registering CPEs to look for another base station, in the Uplink
Base Threshold field, type the limit.
• To specify the limit of downlink traffic that a base station can handle before the base
station indicates to registering CPEs to look for another base station, in the Downlink
Base Threshold field, type the limit.
5 To specify the maximum number of VoIP calls that a base station can handle, in the Max
VoIP calls per Base field, type the limit.
6 Click Save Zone Changes. The new zone names appear in the Zone column.
Figure 3.6 Base Station Attributes page
CityCentral
CityNorth
CitySouth
CityEast
CityWest
4.0.0
MK