User's Manual
Table Of Contents
- Chapter 1: CPEo 450 User Guide
- Chapter 2: Installation
- Chapter 3: Configuration
- Chapter 4: Basic Configuration
- Personalize Menu
- Password Tab
- Device Time Tab
- Device Name Tab
- Restore Factory Settings Tab
- Internet Menu
- WiMAX Security Tab
- Internet Protocol Tab
- Firewall Tab
- Dynamic DNS Tab
- Status Menu
- Network Tab
- Telephony Tab
- Telephony Menu
- Account Tab
- Ring Tone Tab
- Caller ID Tab
- Call Forwarding Tab
- Voice Mail Tab
- Special Number Tab
- Chapter 5: Advanced Configuration
- Chapter 6: Configuring TCP/IP
- Chapter 7: Troubleshooting
- Chapter 8: Important Safety and Legal Information
- This Product complies with the following RF energy exposure standards and guidelines:
- RF Exposure Compliance and Control Guidelines and Operating Instructions
- FCC Regulatory Information
- Industry Canada Statement
- IC Radiation Exposure Statement:
- EU Declaration of Conformity
- Caring for the Environment
- Disposal of Motorola Equipment in EU Countries
- Disposal of Motorola Networks Equipment in Non-EU countries
- CMM Disclosure
- Copyrights and Trademarks
- Copyrights
- Usage and Disclosure Restrictions
CPEo 450 User Guide 1
Table 1-1 LED Indicators
LED Status
Power Status The LED indicator is:
• On - the power to Gateway is on
• Chasing - power to the Gateway is off
Gateway Status The status of the LED indicators:
• Off - the Gateway is not powered on
• On - normal operation
• Flashing - error condition. Contact your service
provider for additional details.
WiMAX Status The status of some or all of the LED indicators:
• Off - the Gateway is not powered on
• On - normal operation
• Flashing - error condition. Contact your service
provider for additional details.
LAN Port The LED indicator is:
• On - LAN Port is connected
• Off - LAN Port is not connected
• Blinking - LAN port is active.
Phone Port Typical RJ 11 ports do not support LED indicators.
Please check for dial tone.
Signal Strength
• All LEDs are off, no signal
• LEDs will display a left to right chase pattern
when the device is attempting to locate and
connect to the network
• All LEDs are on, full signal
* NOTE* Number of LED’s lit indicate the received
signal strength.
Bottom Panel
The bottom panel of the units contains a VoIP port, and an Ethernet port.
68P09306A78-A 1-3
JAN 2010