User Manual
Table Of Contents
- Preface Overview
- About this guide
- Additional documentation
- Typographical conventions this guide uses
- Where to go for more help
- Chapter overview
- System overview
- Installation overview
- Planning the installation
- Chapter overview
- Before you begin
- Using Terminal Emulation or Telnet to help configure base stations
- Setting base station configuration parameters
- Chapter overview
- Before you begin
- Cell wiring
- Base station connectors
- Mounting the base station
- Connecting the antenna to the base station
- Connecting the GPS equipment to a base station
- Connecting to the backbone network
- Powering base stations
- Verifying system operation
- Appendix overview
- Appendix overview
1-4 Configuring, Installing, and Using Base Stations
information, refer to the section, “Connecting to the backbone network” on
page 3-26 in this guide.
8 Power the base stations by connecting the TVS module to the power supply.
For more information, refer to the section, “Powering base stations” on
page 3-27 in this guide.
9 Before leaving the site, verify that the system is operating. For more
information, refer to the section, “Verifying system operation” on page 3-28 in
this guide.
Planning the installation
This section describes issues you need to consider before you install the base
stations, including:
• Location considerations
• Service provider equipment components
Choosing an installation location
The base station’s location at a site depends on many factors, including the site’s
physical environment, the coverage pattern you want to achieve, and the ease of