User Manual
Table Of Contents
- Preface Overview
- About this guide
- Additional documentation
- Typographical conventions this guide uses
- Where to go for more help
- Chapter overview
- System overview
- Installation overview
- Planning the installation
- Chapter overview
- Before you begin
- Using Term or Telnet to help configure base stations
- Setting base station configuration parameters
- Chapter overview
- Before you begin
- Cell wiring
- Base station connectors
- Mounting the base station
- Connecting the antenna to the base station
- Connecting the GPS equipment to a base station
- Connecting to the backbone network
- Powering base stations
- Verifying system operation
- Appendix overview
- Appendix overview
xi
Additional documentation
If you cannot find the information you need in this guide, you may want to refer to
the documents described in Table ii.
How to obtain additional documentation
These documents are available in hard copy format. You can also download
documents from the NextNet Wireless web site. You need a user name and
password to do so. To download the documentation:
1 Use your Internet browser to go to:
www.nextnetwireless.com
2 On the home page, click the Products link.
3 On the page that appears, click the product name for which you want
documentation.
4 Click the document link.
5 A list of documentation appears. To access the documentation file, click
the title of the file you want to review.
Table ii
Additional documentation
Guide Description
Getting Started with the
Expedience System
Provides an overview of the Expedience
system, its components, its network
architecture, and options for selecting a
deployment scheme for the system in your
backbone network.
Using the NextNet Operating
System (NNOS)
Describes the operating system commands
you can use to configure and control the
Expedience system, as well as the
interfaces (command line and Web) that
you can use to issue NNOS commands to
base stations and CPEs.
Installing and using the CPE Intended for use by your subscribers, this
guide describes how to install a CPE at a
subscriber site. The CPE is completely
installable by your subscribers.
White paper TBD