User Manual

WINDOWS XP: SETTING UP THE NETWORK CONNECTION

1. From the Start menu, select Settings. Then select Network Connections.

2. Right click the connection you want to alter; that is, the name of your NIC. From the pop-

up menu, select Properties.

3. The Local Area Connection Properties window appears. Select the Internet Protocol

(TCP/IP) item. Click Properties.

4. Activate the Obtain an IP Address automatically radio button.

5. Turn off your computer.

PLUGGING IN THE RSU

You can connect the RSU directly to a computer, or you can connect it to a small office/home

office (SOHO) network.

• If you are directly connecting the RSU to your computer, complete the steps in this section.

• If you are connecting the RSU to a network, refer to the section “Connecting the RSU to a

network” on page 13 in this guide.

To plug in the RSU:

1 On the side of the RSU, locate the Ethernet jack. Plug one end of the Ethernet cable into the

Ethernet jack (Figure 2).

2 Connect the RSU’s AC power cord to the power source, then plug the power cord into a wall

outlet. Plug the power source cord into the side of your RSU (Figure 2).

Figure 2: Ethernet Jack Location on Side of RSU