User Manual

10 Installing and using the Expedience OSU
5 On the bottom are of the mounting bracket, partially tighten the bolt on the bottom of the
OSU.
6 Plug in the circular end of the Ethernet/power cable in the bottom of the OSU. Provide
strain relief by making a loop in the cable and strapping it to the lower part of the
mounting bracket.
Note: You will fully tighten both bolts in the section, “(Optional) Finding the strongest
service provider signal” on page 12.
Running cables through building’s wall
The power/Ethernet cable runs from inside the building to the OSU.
1 In the desired location, drill a 3/4 inch (18 mm) hole through the wall.
2 Draw one end of the RJ-45 cable through the hole.
3 Route the RJ-45 power/Ethernet cable to the location where the power supply is to be
plugged in.
4 After completing the installation, seal the hole with a silicone or acrylic caulking material.
Connecting the ground wire
The OSU must be grounded to a ground rod in the earth near your building. Make sure your
ground cable does not exceed a 50 foot maximum to the ground rod.
To ground the OSU:
1 Connect the ground wire from the OSU to the ground rod in the ground next to the
building.
2 Attach all wires to the building by using electrical staples. Use drip loops as needed.