User Manual

4 Tighten the clamp so the bracket assembly and attached OSU are tight on the pole.

Connecting Ethernet / power cable to OSU

1 Cut an as-needed length of outdoor-rated category-5 Ethernet cable for chosen the

installation site. The maximum cable length is 200 feet.

2 Terminate the cable using standard RJ-45 connectors.

3 To access the Ethernet connector compartment inside the OSU, open the Ethernet

connector door:

a Unscrew the small screws at the bottom of the connector door.

b Flip the door up toward the top of the OSU.

4 Coat the end of the Ethernet connector with silicone grease.

5 Plug the grease-coated end of the Ethernet/power cable into the jack inside the Ethernet

connector compartment.

6 Make sure the Ethernet / power cable will fit snugly in the U-shape cable relief of the

Ethernet connector door.

7 To shut the Ethernet connector door, flip the door down toward the bottom of the OSU

and tighten the door’s small screws.

8 Run the Ethernet / power cable down along the building.

9 Fasten the cable to the building according to local building codes.

Figure 6 Pole clamp and tightening clamp screws