User's Manual

RF STATEMENT
Medical Electrical Equipment needs special precautions regarding EMC and needs to be installed and
put into service according to the EMC information provided in the following.
– Interference may occur in the vicinity of equipment marked with
– Portable and mobile RF communication equipment (e.g. cell phones) can affect Medical Electrical
Equipment.
– The use of accessories and cables other than those specified may result in increased emissions or
decreased immunity
– The device uses RF energy only for its internal function. Therefore, its RF emissions are very low
and are not likely to cause any interference in nearby electronic equipment
– The device is suitable for use in all establishments, including domestic establishments and those
directly connected to the public low voltage power supply network that supplies buildings used for
domestic purposes
– Portable and mobile RF communications equipment should be used no closer to any part of the
device, including cables, than the recommended separation distance calculated from the equation
applicable to the frequency of the transmitter
– The device is intended for use in an electromagnetic environment in which radiated RF
disturbances are controlled. Any other accessories, transducers and cables may result in increased
emissions or decreased immunity and EMC performance.
– The device should not be used adjacent to or stacked with other equipment and that if adjacent or
stacked use is necessary, which should be observed to verify normal operation in the configuration in
which it will be used.
Medical Electrical Equipment needs special precautions regarding EMC and needs to be installed and
put into service according to the EMC information provided in the following. Portable and mobile RF
communication equipment (e.g. cell phones) can affect Medical Electrical Equipment. The use of
accessories and cables other than those specified may result in increased emissions or decreased
immunity of the unit.
Guidance and manufacturer’s declaration
-
electromagnetic emissions
The
Withings Thermo
is intended for use in the electromagnetic environment specified below. The cust
omer
or the user of the Withings Thermo should assure that it is used in such an environment.
Emissions test
Compliance
Electromagnetic
environment - guidance
CE emissions
CISPR11
Group 1
The
SCT01 Withings Thermo
uses RF energy only for its
internal function. Therefore, its RF emissions are very low and
are not likely to cause any interference in nearby electronic
equipment.
RE emissions
CISPR11
Class B
Harmonic emissions
IEC 61000-3-2
Not applicable
The
SCT01 Withings Thermo
is suitable for use in all
establishments, including domestic establishments and those
directly connected to the public low-voltage power supply
network that supplies buildings used for domestic purposes.
Voltage fluctuations/
Flicker emissions
IEC 61000-3-3
Not applicable