Nokia Holder Easy Mount HH-12 4 1 2 3 9249385/2
5 7 6
ENGLISH © 2006 Nokia. All rights reserved. Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. Introduction This mounting device allows you to attach your compatible Nokia mobile holder to the windshield of your vehicle. To use the mounting device with your compatible mobile holder, attach the mounting device to the windshield, adjust the mounting device into the desired position, and attach your mobile holder to the mounting device.
ENGLISH Check that the deployment of the airbag is not blocked or impaired in any way. Ensure that the mounting device or mobile holder is not installed where you might come in contact with it in the event of an accident or collision. Periodically check that the suction cup at the bottom of the mounting device is firmly attached to the windshield, especially if the ambient temperature changes a lot. Never leave the mounting device inside the vehicle in direct sunlight or in excessive heat.
ENGLISH cup and the windshield. Check that the suction cup is firmly attached. To detach the mounting device from the windshield, carefully push the locking lever toward the top of the mounting device (3), and pull the strap located on the edge of the suction cup (4). Set to the desired position Do not adjust the mounting device while driving.
ENGLISH until the phone is firmly in place. To release the phone, press the button below the left clamp. The mobile holder CR-39 supports mobile devices with the following dimensions: height 95 - 120 mm, width 42 - 55 mm, thickness 13 - 26 mm, weight 200 g at maximum. When attaching a mobile holder, ensure that the phone display is clearly visible for the user. For your safety, install the holder in the upright position.
