Users Manual Part 1

Nokia FastMile 4G Receiver Product Overview Physical interfaces
Issue: DRAFT 3TG-00386-ABGA-TCZZA 53
8 Physical interfaces
8.1 Physical interfaces of the Compact mono-band and ABA models
8.2 Physical interfaces of the Compact multi-band models
8.1 Physical interfaces of the Compact
mono-band and ABA models
Table 7 describes the physical interfaces of the Compact mono-band and ABA
models of the Nokia FastMile 4G Receiver.
Table 7 Physical interfaces of the Compact mono-band and ABA models
of the Nokia FastMile 4G Receiver
Interface Description
Ground point Point for connecting to external ground.
Connection to the ground point is not required.
Located on the underside of the unit; see Figure 11.
Ethernet cable Ethernet connectivity for the Compact mono-band and ABA models is through a
pre-attached 3 m (9.8 ft) cat5e shielded UV resistant Ethernet cable; the same cable is
also used for power (PoE as per IEEE802.3 at type-2). PoE must be provided by a
Nokia-approved residential gateway or a Nokia-approved PoE injector (see section
11.2 for information about PoE injectors for use with the FastMile 4G Receiver). The
4G01-A and 4G03-A Compact mono-band models are also available with a
pre-attached 20 m (65.6 ft) Cat5e shielded UV resistant twisted pair Ethernet cable.<<
confirm 4G01-A >>
Located on the underside of the unit; see Figure 11.
The pre-attached Ethernet cable has a male RJ 45 connector at the free end.
An additional length of cat5e shielded UV resistant Ethernet cabling can be attached to
the Ethernet cable up to a maximum of 80 m (262 ft) in combined length. A waterproof
IP67 female RJ 45 plug is needed to connect the Ethernet cabling to the Ethernet cable
of the Nokia FastMile 4G Receiver.
Status LED Single multifunction LED that indicates status information for the Nokia FastMile 4G
Receiver.
Located on the underside of the unit; see Figure 11.
See section 10.1 for the behavior of the status LED of the Compact mono-band and
ABA models.
Reset button Button to reset the Nokia FastMile 4G Receiver.
Located on the underside of the unit; see Figure 11.
(1 of 2)