Users Manual Part 1

Nokia FastMile 4G Receiver Product Overview Power information
Issue: DRAFT 3TG-00386-ABGA-TCZZA 63
11 Power information
11.1 Power information for the Nokia FastMile 4G Receiver
11.2 Available PoE injectors
11.1 Power information for the Nokia FastMile 4G
Receiver
The Nokia FastMile 4G Receiver receives power though a Cat5e shielded Ethernet
cable that must be connected to a Nokia-approved residential gateway or a
Nokia-approved PoE injector (see section 11.2 for information about PoE injectors
available from Nokia for use with the FastMile 4G Receiver).
• Compact mono-band and ABA models have a pre-attached Cat5e shielded
twisted pair Ethernet cable with a male RJ 45 connector at the free end. An
additional length of cat5e shielded Ethernet cabling can be attached to the
Ethernet cable up to a maximum of 80 m (262 ft) in combined length. A waterproof
IP67 female RJ 45 plug is needed to connect the Ethernet cabling to the Ethernet
cable of the Nokia FastMile 4G Receiver. See section 8.1 for more information
about the pre-attached Ethernet cable.
• Compact multi-band models have an Ethernet port that has a female RJ 45
connector, and require a customer-supplied Ethernet cable (See section 8.2 for
more information about the Ethernet port):
• the Model 4G17-A has a floating ground design that supports a cat5e shielded or
non-shielded twisted pair Ethernet cable with standard pinouts that is up to a
maximum of 80 m (262 ft) in length <<
confirm all this info >>
• all other Compact multi-band models require a cat5e shielded Ethernet cable with
standard pinouts that is a maximum of 80 m (262 ft) in length
See section 12.4 for power consumption information.
11.2 Available PoE injectors
If the Nokia FastMile 4G Receiver is going to be powered through a PoE injector, the
PoE injector must be a Nokia-approved PoE injector.