After Sales Technical Documentation FIXED HANDSFREE CAR KIT (CARK30) INSTALLATION GUIDE Original, 09/94 NMP Part No.
CARK30 Installation Guide After Sales Technical Documentation AMENDMENT RECORD SHEET Amendment Number Page 2 Date Inserted By Comments Original, 09/94
After Sales CARK30 Installation Guide Technical Documentation FIXED HANDSFREE CAR KIT INSTALLATION GUIDE CONTENTS Page No Introduction 5 Unpacking 6 CARK30 Components Parts 7 Cable Junction Box (JBH–1) / In–car Holder (MBH–9) 7 Mounting Plate and Swivel Mount (MKE–1 and HHS–1) 7 Cable Clip (CKH–1) 7 HF Junction Box (HFJ–2) 7 Power Cable (PCH–4) 7 Handsfree Microphone and Speaker (HFM–3 and HFS–6) 8 Modular 8 Pin Extension Cable (SCE–4) 8 Car Radio Muting (XCRM) 8 Ignition Sense (IGN
CARK30 Installation Guide After Sales Technical Documentation [This page intentionally left blank] Page 4 Original, 09/94
After Sales CARK30 Installation Guide Technical Documentation Introduction This installation guide has been prepared to provide the basic information necessary to install the CARK30 car kit. The guide is not intended to be definitive, because different types and models of vehicle will require different installation work. The information given is for general guidance only, and is for use by suitably qualified personnel. NOTE: Refer to the Warnings below before commencing the installation procedure.
CARK30 Installation Guide After Sales Technical Documentation Unpacking Carefully unpack the equipment and ensure that the following items are present. Item Ref.
After Sales CARK30 Installation Guide Technical Documentation CARK30 Component Parts Cable Junction Box (JBH–1) / In–car Holder (MBH–9) This combination enables the phone to operate in handsfree mode. The coil cord, from the cable junction box (JBH–1), plugs into the bottom of the phone; the phone is then placed into the holder (MBH–9) which should be mounted in a convenient dashboard location. When the phone is located in the MBH–9 holder, it will operate in handsfree mode automatically.
CARK30 Installation Guide After Sales Technical Documentation Handsfree Microphone and Speaker (HFM–3 and HFS–6) The handsfree microphone can usually be installed on the driver’s sunvisor or the vehicle’s A–pillar. The main idea is to get the microphone as close to the driver’s mouth as possible, and to attach the microphone to a surface that is mechanically quiet. The microphone connects to the HFJ–2 MIC jack.
After Sales CARK30 Installation Guide Technical Documentation and motors, and another for memory backup purposes. Very often these radios also have a secret code system, which activates itself if a break in the memory supply is detected. Be careful when installing the relay not to interrupt the memory supply (usually marked ACC or +MEM), but to install the relay in the main supply feed.
CARK30 Installation Guide After Sales Technical Documentation Using the MKE–1 mounting bracket as a template, mark and drill four holes and secure the bracket using the four self–tapping screws. Locate the Handsfree Junction Box by positioning it next to the bracket and sliding it sideways until it locks firmly into position. Antenna NOTE: The CARK30 kit is designed to operate with a high quality external antenna.
After Sales CARK30 Installation Guide Technical Documentation The HF Microphone should be located quite close to the driver’s mouth and attached to a surface that does not carry the mechanical vibrations of the vehicle body, since these have a tendency to increase background noise when the phone is operating in handsfree – recommended positions include the driver’s sunvisor or the vehicle’s A–pillar.
CARK30 Installation Guide After Sales Technical Documentation [This page intentionally left blank] Page 12 Original, 09/94
