Installation Guide
Table Of Contents
- Nokia FastMile 4G Receiver Installation Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI environmental and CRoHS guidelines
- 3 ETSI safety guidelines
- 4 ANSI safety guidelines
- 5 Installation overview
- 6 Reviewing safety information
- 7 Identifying package contents
- 8 Reviewing roles and installation prerequisites
- 9 Inserting the SIM card in the Nokia FastMile 4G Receiver
- 10 Determining the mounting location
- 11 Mounting and connecting the Nokia FastMile 4G Receiver
- 12 Troubleshooting
- 12.1 Overview
- 12.2 Subscriber has been registered to a different location
- 12.3 Further installation prevented
- 12.4 SIM not inserted
- 12.5 Failed to connect to the LTE network
- 12.6 Cannot attach to LTE network due to hardware mismatch
- 12.7 The receiver cannot be installed at this position
- 12.8 This subscription ID is not provisioned by the Fastmile Controller
- 12.9 This subscriber ID has already completed a successful installation
- 12.10 Nokia FastMile 4G Receiver firmware upgrade to latest build failed
- 12.11 Nokia FastMile 4G Receiver detached from network
- 12.12 Trace request
- 13 Glossary
- Customer document and product support
Nokia FastMile 4G Receiver Installation Guide ETSI safety guidelines
Issue: 01 3TG-00387-ABBA-TCZZA 21
3.4 ESD safety guidelines
The Nokia FastMile 4G Receiver equipment is sensitive to ESD if opened.
Operations personnel must observe the following ESD instructions when they handle
the Nokia FastMile 4G Receiver equipment.
Service personnel are not required to wear wrist straps when performing normal
installation or maintenance activities.
3.5 Environmental requirements
See the Nokia FastMile 4G Receiver Product Overview for information about
temperature ranges for the Nokia FastMile 4G Receiver equipment and other Nokia
FastMile 4G Receiver specifications.
During operation in the supported temperature range, condensation inside the Nokia
FastMile 4G Receiver equipment caused by humidity is not an issue because the
Nokia FastMile 4G Receiver is a sealed unit.
Caution — This equipment is ESD sensitive if opened. Proper
ESD protections should be used if you open the Nokia FastMile
4G Receiver.