Installation Guide
Table Of Contents
- Nokia FastMile 4G Receiver Installation Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI environmental and CRoHS guidelines
- 3 ETSI safety guidelines
- 4 ANSI safety guidelines
- 5 Installation overview
- 6 Reviewing safety information
- 7 Identifying package contents
- 8 Reviewing roles and installation prerequisites
- 9 Inserting the SIM card in the Nokia FastMile 4G Receiver
- 10 Determining the mounting location
- 11 Mounting and connecting the Nokia FastMile 4G Receiver
- 12 Troubleshooting
- 12.1 Overview
- 12.2 Subscriber has been registered to a different location
- 12.3 Further installation prevented
- 12.4 SIM not inserted
- 12.5 Failed to connect to the LTE network
- 12.6 Cannot attach to LTE network due to hardware mismatch
- 12.7 The receiver cannot be installed at this position
- 12.8 This subscription ID is not provisioned by the Fastmile Controller
- 12.9 This subscriber ID has already completed a successful installation
- 12.10 Nokia FastMile 4G Receiver firmware upgrade to latest build failed
- 12.11 Nokia FastMile 4G Receiver detached from network
- 12.12 Trace request
- 13 Glossary
- Customer document and product support
Nokia FastMile 4G Receiver Installation Guide Reviewing roles and installation prerequisites
Issue: 01 3TG-00387-ABBA-TCZZA 39
•
If the outside Ethernet cabling will be longer than 20 meters (64 feet), you will
need a PoE+ capable surge protector for lightning protection, subject to local
regulations, as indicated in section 8.2.1
• Appropriate fastening means are needed for securing the Nokia FastMile 4G
Receiver to an outside wall or to a pole, such as strapping
• Silicone or other waterproof sealing or caulking compound
• Mechanical tools are required (but are not included) for mounting the Nokia
FastMile 4G Receiver, including:
• TORX T8 screwdriver to open the SIM slot
• The Nokia Wireless app must be installed on an Android mobile phone through
Google Play and the mobile phone must have a Bluetooth adapter, camera,
hardware compass, rotation vector (either a gyroscope or an enhanced
geomagnetic sensor that supports rotation vector), and Android OS 6.0
(Marshmallow) or above; see the Nokia FastMile 4G Receiver Customer Release
Notes for information about accessing the Nokia Wireless app and installing it
• The LTE base station that will be used by the Nokia FastMile 4G Receiver must
be available and functioning
• The residential gateway that will be connecting to the Nokia FastMile 4G Receiver
must be available and reachable; if the residential gateway cannot supply PoE
power to the Nokia FastMile 4G Receiver, then a Nokia-approved PoE injector
must be used in conjunction with the residential gateway.
• The following classes of PoE injectors are available from Nokia for use with the
FastMile 4G Receiver:
• Class I: can comply with EN 60950-1 if grounding is provided on the wall socket;
should be put as close as possible to the place where the Ethernet cable enters the
home; see section 6.2 for information about the Class I PoE injectors that are
available from Nokia.
• Class II: can comply with EN 60950-1 if no grounding is provided on the wall socket;
can also be used if grounding is provided on the wall socket; see section 6.2 for
information about the Class II PoE injectors that are available from Nokia