Installation Guide
Table Of Contents
- Nokia FastMile 4G Receiver Installation Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI environmental and CRoHS guidelines
- 3 ETSI safety guidelines
- 4 ANSI safety guidelines
- 5 Installation overview
- 6 Reviewing safety information
- 7 Identifying package contents
- 8 Reviewing roles and installation prerequisites
- 9 Inserting the SIM card in the Nokia FastMile 4G Receiver
- 10 Determining the mounting location
- 11 Mounting and connecting the Nokia FastMile 4G Receiver
- 12 Troubleshooting
- 12.1 Overview
- 12.2 Subscriber has been registered to a different location
- 12.3 Further installation prevented
- 12.4 SIM not inserted
- 12.5 Failed to connect to the LTE network
- 12.6 Cannot attach to LTE network due to hardware mismatch
- 12.7 The receiver cannot be installed at this position
- 12.8 This subscription ID is not provisioned by the Fastmile Controller
- 12.9 This subscriber ID has already completed a successful installation
- 12.10 Nokia FastMile 4G Receiver firmware upgrade to latest build failed
- 12.11 Nokia FastMile 4G Receiver detached from network
- 12.12 Trace request
- 13 Glossary
- Customer document and product support
Inserting the SIM card in the Nokia FastMile 4G
Receiver
44
Nokia FastMile 4G Receiver Installation Guide
3TG-00387-ABBA-TCZZA Issue: 01
For the Compact multi-band models:
• turn the Nokia FastMile 4G Receiver bottom up
• put the SIM card into the tray in the correct orientation
• use your fingers to hold and push the tray and card all the way into the slot, with the hole
on the right
You need to insert the SIM card deep in the slot until the slot locks the SIM card in place.
3 Re-attach the cover on the SIM card slot after you have inserted the SIM card.
9.3 Extracting the SIM card
Although the following procedure provides instructions for extracting a SIM card from
the Nokia FastMile 4G Receiver, you should contact your Nokia representative for
more detailed information.
Procedure 6 To extract the SIM card from the Nokia FastMile 4G Receiver
1 Use a TORX T8 screwdriver to remove the cover from the SIM card slot of the Nokia FastMile
4G Receiver.
2 Extract the SIM card:
For the Compact mono-band models, use the SIM card tool (“nipple”) supplied with the Nokia
FastMile 4G Receiver to carefully push the SIM card, and then to carefully pick the SIM card
out from the slot.
For the Compact multi-band models, push a needle-like tool into the hole to eject the tray,
and then use your fingers to pick the tray out and get the SIM card.
3 Re-attach the cover on the SIM card slot if you are not installing a new SIM card.
Warning — To avoid the possibility of a short circuit, make sure
that the Nokia FastMile 4G Receiver is in a powered off state
before extracting the SIM card.