Installation Guide
Table Of Contents
- Nokia FastMile 4G Receiver Installation Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI environmental and CRoHS guidelines
- 3 ETSI safety guidelines
- 4 ANSI safety guidelines
- 5 Installation overview
- 6 Reviewing safety information
- 7 Identifying package contents
- 8 Reviewing roles and installation prerequisites
- 9 Inserting the SIM card in the Nokia FastMile 4G Receiver
- 10 Determining the mounting location
- 11 Mounting and connecting the Nokia FastMile 4G Receiver
- 12 Troubleshooting
- 12.1 Overview
- 12.2 Subscriber has been registered to a different location
- 12.3 Further installation prevented
- 12.4 SIM not inserted
- 12.5 Failed to connect to the LTE network
- 12.6 Cannot attach to LTE network due to hardware mismatch
- 12.7 The receiver cannot be installed at this position
- 12.8 This subscription ID is not provisioned by the Fastmile Controller
- 12.9 This subscriber ID has already completed a successful installation
- 12.10 Nokia FastMile 4G Receiver firmware upgrade to latest build failed
- 12.11 Nokia FastMile 4G Receiver detached from network
- 12.12 Trace request
- 13 Glossary
- Customer document and product support
Determining the mounting location
50
Nokia FastMile 4G Receiver Installation Guide
3TG-00387-ABBA-TCZZA Issue: 01
Continue by tapping on “Get started”.
2 After the introductory screen has cleared, the Nokia Wireless app shows an animation of how
to scan the QR code of the Nokia FastMile 4G Receiver so that the app can obtain the MAC
address, unique device identifier, enterprise id, and device type of the Nokia FastMile 4G
Receiver.
The QR code is provided on a sheet of paper in the shipping package of the Nokia FastMile
4G Receiver. The sheet of paper should be saved for anyone who later needs to scan the
QR code when accessing the Nokia FastMile 4G Receiver through a mobile phone after
installation is complete.
Figure 12 shows the screen for the prompt to scan the QR code.
Figure 12 Screen with prompt to scan the QR code for unit that will be
managed by the Nokia Altiplano FastMile Controller through
NETCONF
Tap on “Scan” to start the scan of the QR code.
Use the viewfinder of the phone to align with the QR code.