Installation Guide
Table Of Contents
- Nokia FastMile 4G Receiver Installation Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI environmental and CRoHS guidelines
- 3 ETSI safety guidelines
- 4 ANSI safety guidelines
- 5 Installation overview
- 6 Reviewing safety information
- 7 Identifying package contents
- 8 Reviewing roles and installation prerequisites
- 9 Inserting the SIM card in the Nokia FastMile 4G Receiver
- 10 Determining the mounting location
- 11 Mounting and connecting the Nokia FastMile 4G Receiver
- 12 Troubleshooting
- 12.1 Overview
- 12.2 Subscriber has been registered to a different location
- 12.3 Further installation prevented
- 12.4 SIM not inserted
- 12.5 Failed to connect to the LTE network
- 12.6 Cannot attach to LTE network due to hardware mismatch
- 12.7 The receiver cannot be installed at this position
- 12.8 This subscription ID is not provisioned by the Fastmile Controller
- 12.9 This subscriber ID has already completed a successful installation
- 12.10 Nokia FastMile 4G Receiver firmware upgrade to latest build failed
- 12.11 Nokia FastMile 4G Receiver detached from network
- 12.12 Trace request
- 13 Glossary
- Customer document and product support
Determining the mounting location
80
Nokia FastMile 4G Receiver Installation Guide
3TG-00387-ABBA-TCZZA Issue: 01
12 The Nokia Wireless app uses the signal strength measurement capability of the Nokia
FastMile 4G Receiver to help you find a place to mount the Nokia FastMile 4G Receiver.
The Nokia Wireless app provides the following screens to help you find a place to mount the
Nokia FastMile 4G Receiver based on signal strength measurements:
• swipable information screen that tells you to:
• find a location where the Nokia FastMile 4G Receiver won’t be obstructed (shown in
Figure 40)
• hold the Nokia FastMile 4G Receiver in place and keep it steady (shown in Figure 41)
• try a few locations to find the best signal (shown in Figure 42)
• screen that starts a signal strength measurement by the Nokia FastMile 4G Receiver; you
start a measurement by tapping “Measure Signal”; measurements can take up to five
minutes (shown in Figure 43); for a Compact multi-band model, the signal strength LEDs
will light
• screen that shows a signal strength measurement in progress; you must wait for the
measurement to finish
• screen that shows a signal with average strength, with a recommendation that you take
another measurement
• screen that shows a signal with strong strength, with an indication that this is a good place
to install
• screen that shows a signal with very strong strength, with an indication that this is a good
place to install (shown in Figure 44)
• screen that shows no signal, with a recommendation that you take another measurement
When you have a signal strength measurement that is satisfactory, proceed by tapping on
“Done”.