Installation Guide
Table Of Contents
- Nokia FastMile 4G Receiver Installation Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI environmental and CRoHS guidelines
- 3 ETSI safety guidelines
- 4 ANSI safety guidelines
- 5 Installation overview
- 6 Reviewing safety information
- 7 Identifying package contents
- 8 Reviewing roles and installation prerequisites
- 9 Inserting the SIM card in the Nokia FastMile 4G Receiver
- 10 Determining the mounting location
- 11 Mounting and connecting the Nokia FastMile 4G Receiver
- 12 Troubleshooting
- 12.1 Overview
- 12.2 Subscriber has been registered to a different location
- 12.3 Further installation prevented
- 12.4 SIM not inserted
- 12.5 Failed to connect to the LTE network
- 12.6 Cannot attach to LTE network due to hardware mismatch
- 12.7 The receiver cannot be installed at this position
- 12.8 This subscription ID is not provisioned by the Fastmile Controller
- 12.9 This subscriber ID has already completed a successful installation
- 12.10 Nokia FastMile 4G Receiver firmware upgrade to latest build failed
- 12.11 Nokia FastMile 4G Receiver detached from network
- 12.12 Trace request
- 13 Glossary
- Customer document and product support
Nokia FastMile 4G Receiver Installation Guide Mounting and connecting the Nokia FastMile 4G
Receiver
Issue: 01 3TG-00387-ABBA-TCZZA 89
Procedure 9 To mount and connect the Nokia FastMile 4G Receiver
1 Confirm that the location identified in chapter 10 is suitable for considerations within the
home, and that Ethernet cabling can be safely and securely run from the mounting location
though the wall, and inside the home to the residential gateway or PoE injector, or to the
prospective residential gateway or PoE injector location. The PoE injector must be a
Nokia-approved PoE injector. Class I and Class II PoE injectors are available from Nokia for
use with the FastMile 4G Receiver:
• Class I: can comply with EN 60950-1 if grounding is provided on the wall socket; should
be put as close as possible to the place where the Ethernet cable enters the home; see
section 6.2 for more information
• Class II: can comply with EN 60950-1 if no grounding is provided on the wall socket; can
also be used if grounding is provided on the wall socket; see section 6.2 for more
information
2 Make sure that you have the following from the shipping package as appropriate:
• Nokia FastMile 4G Receiver
• bracket kit consisting of:
• mounting plate
• receiver bracket: note that the receiver bracket is shipped attached to the mounting plate
with three fasteners
• two fasteners for attaching the mounting plate to the Nokia FastMile 4G Receiver
• pole adapter
3 Separate the mounting plate from the receiver bracket and save the three fasteners for
securing the mounting plate to the receiver bracket later on in this procedure.
4 Use the two supplied screws to attach the mounting plate to the back of the Nokia FastMile
4G Receiver as shown in Figure 48. Be sure to orient the mounting plate as shown in the
figure.