CCS Technical Documentation NPD-1 Series Transceivers Disassembly Issue 1 11/2002 Confidential Nokia Corporation
NPD-1 Disassembly Page 2 CCS Technical Documentation Nokia Corporation Confidential Issue 1 11/2002
NPD-1 Disassembly CCS Technical Documentation ESD Protection Step-by-Step Disassembly Instructions 1. Remove the battery cover. 1 Turn phone off. 2 Remove the B-cover by pushing the white button and pushing the cover up as shown above. 3 Remove the A-cover as shown. 4 Remove the battery.
NPD-1 Disassembly CCS Technical Documentation 2. Remove the screws. Remove the six screws using a nonconductive screwdriver. 3. Loosen the LCD assembly. Insert a nonconductive tool on the side of the LCD and carefully snap the LCD assembly out from the D-cover. 4. Remove the LCD assembly. Note: Make sure that the LCD assembly is completely loose from the D-cover snaps to minimize the risk of bending the LCD board.
NPD-1 Disassembly CCS Technical Documentation 5. Separate the PWB from the D-cover assembly. The PWB (shown at left) can be removed by lifting it up from the guide pins in the D-cover. 6. Antenna removal. Antenna: Apply pressure with a nonconductive tool to snap the antenna out from the D-cover. Note: The antenna should not be removed unless it has been verified as a faulty part. The antenna must be replaced after removal. 7. Remove remaining parts as needed.
NPD-1 Disassembly Page 6 CCS Technical Documentation Nokia Corporation Confidential Issue 1 11/2002
