Product Info
Table Of Contents
- Nokia FastMile 4G Receiver Product Overview
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI environmental and CRoHS guidelines
- 3 ETSI safety guidelines
- 4 ANSI safety guidelines
- 5 Product overview
- 6 Functional overview
- 7 Model overview
- 8 Physical interfaces
- 9 SIM cards
- 10 LEDs
- 11 Power information
- 12 Performance information
- 13 Management using the Nokia Wireless app
- 14 Management using the Web UI
- 15 Standards certification
- 16 Appendix A: Specifications
- 17 Appendix B: RF exposure
- 18 Appendix C: FCC statements and label instructions
- 19 Glossary
- Customer document and product support
Nokia FastMile 4G Receiver Product Overview Physical interfaces
Issue: DRAFT 3TG-00386-ABGA-TCZZA 53
8 Physical interfaces
8.1 Physical interfaces of the Compact mono-band and ABA models
8.2 Physical interfaces of the Compact multi-band models
8.1 Physical interfaces of the Compact
mono-band and ABA models
Table 7 describes the physical interfaces of the Compact mono-band and ABA
models of the Nokia FastMile 4G Receiver.
Table 7 Physical interfaces of the Compact mono-band and ABA models
of the Nokia FastMile 4G Receiver
Interface Description
Ground point Point for connecting to external ground.
Connection to the ground point is not required.
Located on the underside of the unit; see Figure 11.
Ethernet cable Ethernet connectivity for the Compact mono-band and ABA models is through a
pre-attached 3 m (9.8 ft) cat5e shielded Ethernet cable; the same cable is also used for
power (PoE as per IEEE802.3 at type-2). PoE must be provided by a Nokia-approved
residential gateway or a Nokia-approved PoE injector (see section 11.2 for information
about PoE injectors for use with the FastMile 4G Receiver). The 4G03-A Compact
mono-band model is also available with a pre-attached 20 m (65.6 ft) Cat5e shielded
twisted pair Ethernet cable.
Located on the underside of the unit; see Figure 11.
The pre-attached Ethernet cable has a male RJ 45 connector at the free end.
An additional length of cat5e shielded Ethernet cabling can be attached to the Ethernet
cable up to a maximum of 80 m (262 ft) in combined length. A waterproof IP67 female
RJ 45 plug is needed to connect the Ethernet cabling to the Ethernet cable of the Nokia
FastMile 4G Receiver.
Status LED Single multifunction LED that indicates status information for the Nokia FastMile 4G
Receiver.
Located on the underside of the unit; see Figure 11.
See section 10.1 for the behavior of the status LED of the Compact mono-band and
ABA models.
Reset button Button to reset the Nokia FastMile 4G Receiver.
Located on the underside of the unit; see Figure 11.
(1 of 2)