PAMS Technical Documentation Chapter 4 UI Module UE4 Original 11/97
PAMS UI Module UE4 Technical Documentation CONTENTS UIF Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Baseband Block Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . The Engine Interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . The LCD Module Interface . . . . . . . . . . . . . . . . . . . . . . . . . . Functional Description .
PAMS Technical Documentation UI Module UE4 UIF Module Introduction The UI module UE4 is a four layer PCB, which is connected to the system/RF PCB with a 28–pin spring connector.
PAMS UI Module UE4 Technical Documentation Baseband Block Diagram Page 4 – 4 Original 11/97
PAMS UI Module UE4 Technical Documentation The Engine Interface Pin Line Symbol 1 2 3 4 5 6 7 8 9 10 11 ROW0 ROW1 ROW2 ROW3 ROW4 COL0 COL1 COL2 COL3 COL4 Signal1 Parameter Keyboard matrix row 0 Keyboard matrix row 1 Keyboard matrix row 2 Keyboard matrix row 3 Keyboard matrix row 4 Keyboard matrix column 0, used for flip identification Keyboard matrix column 1 Keyboard matrix column 2 Keyboard matrix column 3 Keyboard matrix column 4 Flip interrupt, not used Min Typ Max Unit 0 0.3xVBB V 0.
PAMS UI Module UE4 Pin 19 20 21 Line Symbol SDA Technical Documentation Parameter LCDCSX Unit 0 4.0 MH z 0 0.3xVBB V 0.7xVBB VBB 0 0.3xVBB 0.7xVBB VBB LCDRSTX 0 0.3xVBB 0.7xVBB VBB LCD driver chip select LCD driver reset UDGND* Digital ground 23 BUZZER Buzzer PWM control 24 VL Supply voltage 26 Max LCD driver serial data 22 25 Min SPARE LIGHT Typ 0 0 Notes Low High V Low / Active High V Low / Active High V 2.85 V 2.85 V 300 uA 0 0.
PAMS UI Module UE4 Technical Documentation The LCD Module Interface Pin 1 2 3 4 5 Line Symbol VL Parameter Supply voltage SCLK Serial clock input SDA Serial data input LCDCDX LCDCSX Control/display data flag input Chip select input 6 OSC** External clock for LCD 7 UDGND* Ground 8 VOUT DC/DC voltage converter output 9 LCDRSTX Reset Minimum Typical / Nominal Maximum Unit 2.7 2.8 2.85 V 300 uA 0 4.0 MHz 0 VBB V 0 0.3xVBB 0.7xVBB VBB 0 0.3xVBB 0.7xVBB VBB 0 0.
PAMS UI Module UE4 Technical Documentation Functional Description Power Distribution Diagram PWRXON VBB VBATT Buzzer LEDs of Display LEDs of Keybord Display PWR key UAGND UDGND Display Circuit The display circuit includes LCD module GD40 and two capacitors. The LCD module is COG (Chip on Glass) technology. The connection method for chip on the glass is ACF, Adhesive Conductive Film. The LCD module is connected to UI board with gold wired elastomer. Capacitors are placed on UI PCB.
PAMS UI Module UE4 Technical Documentation Keyboard [4V] [2.
PAMS UI Module UE4 Technical Documentation Keyboard Matrix ROW/COL 0 1 2 3 4 0 FLIP Side Key Send End/Mode Side Key 1 NC Soft left Up Down Soft Right 2 NC 1 4 7 * 3 NC 2 5 8 0 4 PWR switch 3 6 9 # NC = Not Connected S Left Up S Right Send Down End 1 2 3 4 5 6 7 8 9 * 0 # Power Key Micro switch is used as a power key on UI module. Circuitry includes micro switch and two diodes which is needed for MAD interface. Power key is connected to CCONT.
PAMS UI Module UE4 Technical Documentation [0V] [0.7V] [2.6V] [1.9V] [0V] [1.4V] [4V] [0V] [1.2V] [0V] [0.5V] [2.6V] [2.
PAMS UI Module UE4 Technical Documentation Display Backlighting is provided by LEDs, three LED on right and three on left side of display. LEDs are compatible with CL270–YG and those are side illuminating. Light is on when LIGHT–signal is in HIGH state. Color of LED is for Pin 14 Line Symbol VBAT Parameter Minimum Battery voltage Typical / Nominal 3.0 43.4 51.4 Maximum Unit Notes 5.1 V Same supply for Buzzer & Keyboard 59.6 mA LEDs Keyboard In keyboard backlighting is made by 6 LEDs.
PAMS Technical Documentation UI Module UE4 Speaker The speaker is sealed to A–cover and UI PCB with silicon gasket. With that the frequency response is more constant. Speaker needs 6pcs of 1.2mm holes under component for leaking sound pressure into RF–section through UI module and 7pcs of 0.9mm holes left corner of UIM to leak from RF–section back to up cavity of phone. RF–section between UI module and engine acts like sound cage which is known.
PAMS UI Module UE4 Technical Documentation Parts list of UE4 (EDMS Issue 9.
PAMS Technical Documentation S001 5200120 Push button switch 6.4x5.2 smd 9850046 PCB UE4 118.0X41.5X0.8 M4 4/PA 9850046 PC board UE4 Original 11/97 UI Module UE4 118.0x41.5x0.
PAMS UI Module UE4 Technical Documentation This page intentionally left blank.
