PAMS Technical Documentation NPM–9 Series Transceivers Full Car Kit CARK132 Installation Guide Issue 1 02/2002 Nokia Corporation
NPM–9 CARK132 PAMS Technical Documentation CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Components of CARK132 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Component Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Testing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
NPM–9 CARK132 PAMS Technical Documentation Introduction This installation guide has been prepared to provide the basic information necessary to install CARK132. This guide is not intended to be definitive, because different types and models of vehicles will require different installation work. The information given is for general guidance only. The terms of warranty demand that this car kit be installed by an experienced installer and only genuine Nokia parts are used.
NPM–9 CARK132 PAMS Technical Documentation Components of CARK132 The CARK132 includes the following parts: Advanced Active Car Holder Advanced HF Unit Power Cable Mounting Plate Swivel Mount HF Microphone HF Speaker MCC–5 HFU–5 PCH–4J MKU–1 HHS–9 HFM–8 HFS–12 HHS-9 MKU–1 HFU-5 MCC-5 PCH-4J AMD–2 HFS–12 HFM-8 Please, note that the items enclosed in broken-line (phone & antenna) are not supplied with CARK132. The external antenna AMD–2 is recommended.
NPM–9 CARK132 PAMS Technical Documentation Component Parts Advanced Active Car Holder MCC-5 The holder for the mobile phone is attached to the vehicle’s interior always in an upward position, shown in Fig. 2 below, using the swivel mount HHS-9. The mounting is secured with a screw (included with HHS-9). The screw recess is covered with the NOKIA logo plate. The cable with the plug-in connector from MCC-5 connects to the PHONE socket in HFU-5 (The other cable from MCC-5 connects to the external antenna.
NPM–9 CARK132 PAMS Technical Documentation Installation For an example of installation locations, please see the CARK132 cover page. Note: Ensure that the battery of the vehicle is disconnected before you start the installation or making changes to the installations, and that it remains disconnected during the installation procedure. The HFU-5 and the different parts are connected as mentioned in the section ”Component Parts”.
NPM–9 CARK132 PAMS Technical Documentation Car Radio Muting CRM The car kit offers a feature that can mute the car radio automatically during a conversation. The following is the circuit diagram of CRM. Relay (12 V) GND CAR RADIO 87A 30 87 To CRM line (yellow wire) 85 86 12 V d.c. Supply for car radio 12 V d.c. Fuse 200 mA (not supplied) Another possibility is to use a special muting unit, which mutes the radio by connecting load resistors to the speaker lines of the car radio.
NPM–9 CARK132 PAMS Technical Documentation This page intentionally left blank.
