Product Guide
Table Of Contents
- Beacon 2 Product Guide
- Legal notice
- Contents
- List of tables
- List of figures
- About this document
- 1 What’s new
- 2 ANSI CPE safety guidelines
- 3 ETSI CPE safety guidelines
- 4 ETSI environmental and CRoHS guidelines
- 5 Beacon 2 unit data sheet
- 5.1 Overview
- 5.2 Beacon 2 part numbers and identification
- 5.3 Beacon 2 general description
- 5.4 Beacon 2 software and installation feature support
- 5.5 Beacon 2 interfaces and interface capacity
- 5.6 Beacon 2 LEDs
- 5.7 Beacon 2 detailed specifications
- 5.8 Beacon 2 functional blocks
- 5.9 Beacon 2 responsible party
- 5.10 Beacon 2 special considerations
- 6 Install a Beacon 2
- 7 Replace a Beacon 2
- 8 Configure a Beacon 2
The customer premises equipment complies with the requirements of EN 60950-1 and EN 62368-1,
Safety of Information Technology Equipment for use in a restricted location.
• ETS 300 019-2-1 Storage Class T1.2
• ETS 300 019-2-2 Transport Class T2.3
• ETS 300 019-2-3 Stationary Class T3.2
3.2.3 Environmental standard compliance
The customer premises equipment complies with the EN 300 019 European environmental
standards.
3.2.4 CE RED RF Radiation Exposure Statement
This device complies with CE RED radiation exposure limits set forth for an uncontrolled
environment. To comply with CE RED RF exposure compliance requirements, this grant is
applicable only for mobile configurations. The antennas used for the transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
3.2.5 Resistibility requirements compliance
The customer premises equipment complies with the requirements of ITU Recommendation K.21
for resistibility of telecommunication equipment installed in customer premises to over voltage and
overcurrents.
3.2.6 Acoustic noise emission standard compliance
The customer premises equipment complies with EN 300 753 acoustic noise emission limit and test
methods.
3.3 Electrical safety guidelines
This section provides the electrical safety guidelines for the customer premises equipment.
Note: The devices comply with the U.S. National Electrical Code. However, local electrical
authorities have jurisdiction when there are differences between the local and U.S. standards.
The devices comply with BS EN 61140.
3.3.1 Power supplies
The use of any non-Nokia approved power supplies or power adapters is not supported or
endorsed by Nokia. Such use will void any warranty or support contract with Nokia. Such use
greatly increases the danger of damage to equipment or property.
3.3.2 Cabling
The following are the guidelines regarding cables used for the customer premises equipment:
• All cables must be approved by the relevant national electrical code.
ETSI CPE safety guidelines
Electrical safety guidelines
WiFi Beacon 2
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-49294-AAAA-TCZZA
December 2020
26 Issue 1