Product Guide
Table Of Contents
- Beacon 2 Product Guide
- Legal notice
- Contents
- List of tables
- List of figures
- About this document
- 1 What’s new
- 2 ANSI CPE safety guidelines
- 3 ETSI CPE safety guidelines
- 4 ETSI environmental and CRoHS guidelines
- 5 Beacon 2 unit data sheet
- 5.1 Overview
- 5.2 Beacon 2 part numbers and identification
- 5.3 Beacon 2 general description
- 5.4 Beacon 2 software and installation feature support
- 5.5 Beacon 2 interfaces and interface capacity
- 5.6 Beacon 2 LEDs
- 5.7 Beacon 2 detailed specifications
- 5.8 Beacon 2 functional blocks
- 5.9 Beacon 2 responsible party
- 5.10 Beacon 2 special considerations
- 6 Install a Beacon 2
- 7 Replace a Beacon 2
- 8 Configure a Beacon 2
Table 5-5, “Beacon 2 physical connections” (p. 36) describes the physical connections for Beacon
2 devices.
Table 5-5 Beacon 2 physical connections
Connection Description
WPS on/off button This button is used to start the WiFi Protected Setup (WPS) for new WiFi devices.
Reset button Pressing the Reset button for less than 10 seconds reboots the Beacon; pressing the Reset button
for 10 seconds or more restores the Beacon to its factory defaults.
LAN This connection is provided through Ethernet RJ-45 connectors. One 10/100/1000 Base-T Ethernet
interface is supported. The Ethernet ports can support both data and in-band video services.
WAN port This connection is provided through an RJ-45 Gigabit Ethernet interface.
Figure 5-2 Beacon 2 physical connections
36527
WPS
POWER
WAN / LAN 2
LAN 1
RESET
ON/OFF
BUTTON
Beacon 2 unit data sheet
Beacon 2 interfaces and interface capacity
WiFi Beacon 2
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-49294-AAAA-TCZZA
December 2020
36 Issue 1