Product Guide
Table Of Contents
- Beacon 2 Product Guide
- Legal notice
- Contents
- List of tables
- List of figures
- About this document
- 1 What’s new
- 2 ANSI CPE safety guidelines
- 3 ETSI CPE safety guidelines
- 4 ETSI environmental and CRoHS guidelines
- 5 Beacon 2 unit data sheet
- 5.1 Overview
- 5.2 Beacon 2 part numbers and identification
- 5.3 Beacon 2 general description
- 5.4 Beacon 2 software and installation feature support
- 5.5 Beacon 2 interfaces and interface capacity
- 5.6 Beacon 2 LEDs
- 5.7 Beacon 2 detailed specifications
- 5.8 Beacon 2 functional blocks
- 5.9 Beacon 2 responsible party
- 5.10 Beacon 2 special considerations
- 6 Install a Beacon 2
- 7 Replace a Beacon 2
- 8 Configure a Beacon 2
3
Connect the Ethernet cable to the RJ-45 port; see Figure 6-1, “Beacon 2 connections” (p. 45)
for the location of the RJ-45 port.
4
Connect the WAN cable to the RJ-45 WAN port; see Figure 6-1, “Beacon 2 connections”
(p. 45)
for the location of the RJ-45 WAN port.
5
Connect the power cable to the power connector.
Note: Observe the following:
• Units must be powered by a Listed or CE approved and marked limited power source
Figure 6-1 Beacon 2 connections
36527
WPS
POWER
WAN / LAN 2
LAN 1
RESET
ON/OFF
BUTTON
Install a Beacon 2
Procedure
WiFi Beacon 2
December 2020
Issue 1 45
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-49294-AAAA-TCZZA