Product Guide
Table Of Contents
- Beacon 2 Product Guide
- Legal notice
- Contents
- List of tables
- List of figures
- About this document
- 1 What’s new
- 2 ANSI CPE safety guidelines
- 3 ETSI CPE safety guidelines
- 4 ETSI environmental and CRoHS guidelines
- 5 Beacon 2 unit data sheet
- 5.1 Overview
- 5.2 Beacon 2 part numbers and identification
- 5.3 Beacon 2 general description
- 5.4 Beacon 2 software and installation feature support
- 5.5 Beacon 2 interfaces and interface capacity
- 5.6 Beacon 2 LEDs
- 5.7 Beacon 2 detailed specifications
- 5.8 Beacon 2 functional blocks
- 5.9 Beacon 2 responsible party
- 5.10 Beacon 2 special considerations
- 6 Install a Beacon 2
- 7 Replace a Beacon 2
- 8 Configure a Beacon 2
DANGER
Hazard
Hazardous electrical voltages and currents can cause serious physical harm or death. Always use
insulated tools and follow proper safety precautions when connecting or disconnecting power
circuits.
Make sure all sources of power are turned off and have no live voltages present on feed lines or
terminals. Use a voltmeter to measure for voltage before proceeding.
Always contact the local utility company before connecting the enclosure to the utilities.
CAUTION
Service Disruption
Keep indoor devices out of direct sunlight. Prolonged exposure to direct sunlight can damage the
unit.
Note: Observe the local and national laws and regulations that may be applicable to this
installation.
Observe the following:
• The device should be installed in accordance with the applicable requirements of the NEC
or CEC. Local authorities and practices take precedent when there is conflict between the
local standard and the NEC or CEC.
• Indoor units must be installed with cables that are suitably rated and listed for indoor use.
• See the detailed specifications in the
Chapter 5, “Beacon 2 unit data sheet” for the
temperature ranges for these devices.
7.7 Procedure
Use this procedure to replace a Beacon 2.
1
Power down the unit by using the on/off power switch. See Figure 7-1, “Beacon 2 connections”
(p. 49)
for the connections on the Beacon 2.
Replace a Beacon 2
Procedure
WiFi Beacon 2
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-49294-AAAA-TCZZA
December 2020
48 Issue 1