Product Guide
Table Of Contents
- Beacon 2 Product Guide
- Legal notice
- Contents
- List of tables
- List of figures
- About this document
- 1 What’s new
- 2 ANSI CPE safety guidelines
- 3 ETSI CPE safety guidelines
- 4 ETSI environmental and CRoHS guidelines
- 5 Beacon 2 unit data sheet
- 5.1 Overview
- 5.2 Beacon 2 part numbers and identification
- 5.3 Beacon 2 general description
- 5.4 Beacon 2 software and installation feature support
- 5.5 Beacon 2 interfaces and interface capacity
- 5.6 Beacon 2 LEDs
- 5.7 Beacon 2 detailed specifications
- 5.8 Beacon 2 functional blocks
- 5.9 Beacon 2 responsible party
- 5.10 Beacon 2 special considerations
- 6 Install a Beacon 2
- 7 Replace a Beacon 2
- 8 Configure a Beacon 2
Table 8-3 WAN Status parameters
Field Description
WAN connection list Select the WAN connection for which to display the WAN status from the list.
Access Type Displays the access type for the selected WAN connection.
Connection Mode Connection mode of the WAN connection.
Enable/Disable Displays if the WAN connection is enabled or disabled.
VLAN Indicates the VLAN ID.
WAN Link Status Indicates if the WAN link is up or down.
Ethernet Link Status Indicates if the Ethernet link is up or down.
Tx Packets Indicates transmitter packets.
Rx Packets Indicates receiver packets.
Tx Dropped Indicates transmitter packets dropped.
Rx Dropped Indicated receiver packets dropped.
Err Packets Indicates error packets.
You can click the Refresh icon
to display up-to-date information.
END OF STEPS
8.7 Viewing WAN Status IPv6
1
Click Status in the menu bar.
2
Click WAN Status IPv6 in the left pane. The WAN Status page displays the following
information.
Configure a Beacon 2
Viewing device information and connection status
Viewing WAN Status IPv6
WiFi Beacon 2
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-49294-AAAA-TCZZA
December 2020
62 Issue 1