Product Guide
Table Of Contents
- Beacon 2 Product Guide
- Legal notice
- Contents
- List of tables
- List of figures
- About this document
- 1 What’s new
- 2 ANSI CPE safety guidelines
- 3 ETSI CPE safety guidelines
- 4 ETSI environmental and CRoHS guidelines
- 5 Beacon 2 unit data sheet
- 5.1 Overview
- 5.2 Beacon 2 part numbers and identification
- 5.3 Beacon 2 general description
- 5.4 Beacon 2 software and installation feature support
- 5.5 Beacon 2 interfaces and interface capacity
- 5.6 Beacon 2 LEDs
- 5.7 Beacon 2 detailed specifications
- 5.8 Beacon 2 functional blocks
- 5.9 Beacon 2 responsible party
- 5.10 Beacon 2 special considerations
- 6 Install a Beacon 2
- 7 Replace a Beacon 2
- 8 Configure a Beacon 2
2
Click Access control in the left pane. The Access control page displays.
3
Configure the following parameters:
Table 8-15 Access control parameters
Field Description
Enable Trusted Network Select this checkbox to choose the trusted network.
ICMP, Telnet, SSH, HTTP, TR069,
HTTPS, SFTP
Select an access control level for each protocol:
WAN side: Allow, Deny, or Trusted Network Only.
LAN side: Allow or Deny.
Trusted Network
Source IP Start Enter a start IP address for the new subnet trusted network.
Source IP End Enter an end IP address for the new subnet trusted network.
4
Click Save.
Figure 8-20 Access control page
Configure a Beacon 2
Configuring Security
Configuring Access control
WiFi Beacon 2
December 2020
Issue 1 85
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-49294-AAAA-TCZZA