Nokia Bluetooth Headset BH-100 7 6 9 8 Issue 1 10
DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this HS-78W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. 0434 © 2007 Nokia. All rights reserved. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited.
other countries. Diversion contrary to law is prohibited. Introduction The Nokia Bluetooth Headset BH100 allows you to make and receive calls while on the move. You can use the headset with compatible phones that support Bluetooth wireless technology. Read this user guide carefully before using the headset. Also read the user guide for your phone, which provides important safety and maintenance information. Keep the headset out of reach of small children.
Get started The headset contains the following parts shown on the title page: indicator light (1), power key (2), microphone (3), charger connector (4), answer/end key (5), and changeable earloop (6). Before using the headset, you must charge the battery and pair the headset with a compatible phone. Nokia for use with this particular enhancement. The use of any other types may invalidate any approval or warranty and may be dangerous. For availability of approved enhancements, please check with your dealer.
charging. It may take a while before charging starts. If charging does not start, disconnect the charger, plug it in again, and retry. Charging the battery fully may take up to 1 hour and 30 minutes. 4. When the battery is fully charged, the indicator light turns green. Disconnect the charger from the headset and the wall outlet. The fully charged battery has power for up to 6 hours and 30 minutes of talktime or up to 150 hours of standby time.
need to make the connection separately after pairing. You only need to pair the headset with your phone once. If the pairing is successful, the headset beeps and appears in the phone menu where you can view the currently paired Bluetooth devices. The headset is now ready for use. Basic use Place the headset on the ear Change the earloop The headset has an earloop attached around it. To use the headset without placing the earloop over the ear, plug the earpiece into your ear.
the answer/end key twice while no call is in progress. If your phone supports voice dialing with the headset, press and hold the answer/end key when no call in progress, and proceed as described in the user guide of your phone. To answer or end a call, press the answer/end key. To reject an incoming call, press the answer/end key twice. To adjust the headset volume during a call, use the volume keys on your phone.
Never use any charger that is damaged. Leaving the device in hot or cold places, such as in a closed car in summer or winter conditions, will reduce the capacity and lifetime of the battery. Always try to keep the battery between 15°C and 25°C (59°F and 77°F). A device with a hot or cold battery may not work temporarily, even when the battery is fully charged. Battery performance is particularly limited in temperatures well below freezing. Do not dispose of batteries in a fire as they may explode.
its normal temperature, moisture can form inside the device and damage electronic circuit boards. • Do not attempt to open the device. • Do not drop, knock, or shake the device. Rough handling can break internal circuit boards and fine mechanics. • Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. • Do not paint the device. Paint can clog the moving parts and prevent proper operation.