Nokia Bluetooth Headset BH-609 Issue 2.
DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this BH-609 product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/ EC. A copy of the Declaration of Conformity can be found at http:// www.nokia.com/phones/ declaration_of_conformity/. © 2010-2011 Nokia. All rights reserved. Bluetooth is a registered trademark of Bluetooth SIG, Inc.
If the application is not already installed in your mobile device, check the availability of the application for your device from the support pages of this headset at www.nokia.com/support. If the application is not available for your Nokia device, you can use the shortcut key to mute the microphone during a call. Bluetooth compatibility The headset is compliant with the Bluetooth Specification 2.1 + EDR supporting the Headset Profile 1.1 and Hands-Free Profile 1.5.
Charge the battery 1. Connect the charger to a wall outlet. 2. Connect the charger cable to the charger connector. The red indicator light is displayed during charging. Charging the battery fully may take up to 1 hour. Charging the battery with the AC-15 charger for 15 minutes provides up to 2 hours of talk time. 3. When the battery is fully charged, the green indicator light is displayed. Disconnect the charger from the headset, then from the wall outlet.
devices. When the headset is 1. Make sure your mobile device is connected to at least one device and switched on and the headset is is ready for use, the blue indicator off. light flashes slowly. If the headset 2. If the headset has not been has not been paired with a device, it previously paired with a device, automatically enters pairing mode. switch on the headset.
4. Select the headset from the list of found devices. 5. If necessary, enter the passcode 0000 to pair and connect the headset to your device. In some devices, you may need to make the connection separately after pairing. When the headset is connected to at least one device and is ready for use, the blue indicator light flashes slowly.
and push the new earpad into place (13). Place the headset on the ear To place the headset on the ear, gently push the earpiece against your ear. Point the headset towards your mouth (11). You can rotate the earpad to keep the headset securely in the ear (14). For example, if you use the headset on the right ear, you may need to rotate the earpad to the right for the best fit. If you wear an earring, make sure it is not accidentally attached to the earpad.
progress, press and hold the multifunction key for about 2 seconds. Proceed as described in the user guide of the mobile device. To answer or end a call, press the multifunction key. To reject a call, press this key twice. To mute or unmute the microphone during a call, press the middle of the volume key. The headset beeps, and a related icon is displayed on your device (if supported by the device).
By default, the headset can only be connected to one device at a time. To allow the headset to connect to two devices, switch off the headset, and press and hold the multifunction key, and slide and hold the volume key up for about 5 seconds. The green indicator light flashes once. To allow the headset to connect to only one device, switch off the headset, and press and hold the multifunction key, and slide and hold the volume key down for about 5 seconds. The yellow indicator light flashes once.
on hold active on the other device, press the multifunction key. To switch between the active call on one device and the call on hold on the other device, press and hold the multifunction key for about 2 seconds. Turn lights on or off about 5 seconds. The green indicator light flashes once.
sure the headset is charged, switched on, and paired with the device.
