Product Guide
Table Of Contents
- 7368 ISAM ONT G-140W-H Product Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI ONT safety guidelines
- 3 ETSI environmental and CRoHS guidelines
- 4 ANSI ONT safety guidelines
- 5 G-140W-H unit data sheet
- 5.1 G-140W-H part numbers and identification
- 5.2 G-140W-H general description
- 5.3 G-140W-H software and installation feature support
- 5.4 G-140W-H interfaces and interface capacity
- 5.5 G-140W-H LEDs
- 5.6 G-140W-H detailed specifications
- 5.7 G-140W-H GEM ports and T-CONTs
- 5.8 G-140W-H performance monitoring statistics
- 5.9 G-140W-H functional blocks
- 5.10 G-140W-H standards compliance
- 5.11 G-140W-H special considerations
- 6 Install a G-140W-H indoor ONT
- 7 Replace a G-140W-H indoor ONT
- 8 Configure a G-140W-H indoor ONT
- 9 ONT configuration file over OMCI
- Customer document and product support
7368 ISAM ONT G-140W-H Product Guide Configure a G-140W-H indoor ONT
Issue: 01 3FE-48054-AAAA-TCZZA 129
Procedure 35 NTP configuration
1 Select Application > NTP from the top-level menu in the GPON Home Gateway window, as
shown in Figure 51.
Figure 51 NTP window
Table 44 describes the fields in the NTP window.
Table 44 NTP parameters
2 Configure the NTP.
Field Description
Enable NTP Service Select this checkbox to enable the NTP service
Current Time Enter the current local date and time
Primary Time Server Choose a time server from the drop-down menu or choose Customer setting and
enter the address of the time server.
Secondary Time Server Choose a time server from the drop-down menu or choose Customer setting and
enter the address of the time server.
Third Time Server Choose a time server from the drop-down menu or choose Customer setting and
enter the address of the time server.
Interval Time Interval at which to get the time from the time server, in seconds
Time Zone Choose the local time zone from the drop-down menu
Release 06.02.01 | September 2019 | Edition 01