Product Guide
Table Of Contents
- 7368 ISAM ONT G-140W-H Product Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI ONT safety guidelines
- 3 ETSI environmental and CRoHS guidelines
- 4 ANSI ONT safety guidelines
- 5 G-140W-H unit data sheet
- 5.1 G-140W-H part numbers and identification
- 5.2 G-140W-H general description
- 5.3 G-140W-H software and installation feature support
- 5.4 G-140W-H interfaces and interface capacity
- 5.5 G-140W-H LEDs
- 5.6 G-140W-H detailed specifications
- 5.7 G-140W-H GEM ports and T-CONTs
- 5.8 G-140W-H performance monitoring statistics
- 5.9 G-140W-H functional blocks
- 5.10 G-140W-H standards compliance
- 5.11 G-140W-H special considerations
- 6 Install a G-140W-H indoor ONT
- 7 Replace a G-140W-H indoor ONT
- 8 Configure a G-140W-H indoor ONT
- 9 ONT configuration file over OMCI
- Customer document and product support
Configure a G-140W-H indoor ONT
132
7368 ISAM ONT G-140W-H Product Guide
3FE-48054-AAAA-TCZZA Issue: 01
Procedure 37 UPnP and DLNA configuration
1 Select Application > UPnP and DLNA from the top-level menu in the GPON Home Gateway
window, as shown in Figure 53.
Figure 53 UPnP and DLNA window
2 Select the Enable UPnP/DLNA checkbox to enable UPnP/DLNA.
3 Click Save/Apply.
4 STOP. This procedure is complete.
8.2.6 Maintenance
The G-140W-H ONT supports maintenance tasks, including:
• change password
• test WAN speed
• configure LOID
• configure SLID
• manage device
• backup and restore
• upgrade firmware
• reboot device
• restore factory defaults
Release 06.02.01 | September 2019 | Edition 01