Product Guide
Table Of Contents
- 7368 ISAM ONT G-140W-H Product Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI ONT safety guidelines
- 3 ETSI environmental and CRoHS guidelines
- 4 ANSI ONT safety guidelines
- 5 G-140W-H unit data sheet
- 5.1 G-140W-H part numbers and identification
- 5.2 G-140W-H general description
- 5.3 G-140W-H software and installation feature support
- 5.4 G-140W-H interfaces and interface capacity
- 5.5 G-140W-H LEDs
- 5.6 G-140W-H detailed specifications
- 5.7 G-140W-H GEM ports and T-CONTs
- 5.8 G-140W-H performance monitoring statistics
- 5.9 G-140W-H functional blocks
- 5.10 G-140W-H standards compliance
- 5.11 G-140W-H special considerations
- 6 Install a G-140W-H indoor ONT
- 7 Replace a G-140W-H indoor ONT
- 8 Configure a G-140W-H indoor ONT
- 9 ONT configuration file over OMCI
- Customer document and product support
7368 ISAM ONT G-140W-H Product Guide Configure a G-140W-H indoor ONT
Issue: 01 3FE-48054-AAAA-TCZZA 137
Procedure 41 SLID configuration
1 Select Maintain > SLID Configuration from the top-level menu in the GPON Home Gateway
window, as shown in Figure 57.
Figure 57 SLID configuration window
Table 48 describes the fields in the SLID configuration window.
Table 48 SLID configuration parameters
2 Configure the new SLID.
Field Description
Current SLID Displays the current SLID
Enter New SLID Enter new SLID
SLID Mode Choose a SLID mode from the drop-down menu
The default is HEX Mode
Release 06.02.01 | September 2019 | Edition 01