Product Guide
Table Of Contents
- 7368 ISAM ONT G-140W-H Product Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI ONT safety guidelines
- 3 ETSI environmental and CRoHS guidelines
- 4 ANSI ONT safety guidelines
- 5 G-140W-H unit data sheet
- 5.1 G-140W-H part numbers and identification
- 5.2 G-140W-H general description
- 5.3 G-140W-H software and installation feature support
- 5.4 G-140W-H interfaces and interface capacity
- 5.5 G-140W-H LEDs
- 5.6 G-140W-H detailed specifications
- 5.7 G-140W-H GEM ports and T-CONTs
- 5.8 G-140W-H performance monitoring statistics
- 5.9 G-140W-H functional blocks
- 5.10 G-140W-H standards compliance
- 5.11 G-140W-H special considerations
- 6 Install a G-140W-H indoor ONT
- 7 Replace a G-140W-H indoor ONT
- 8 Configure a G-140W-H indoor ONT
- 9 ONT configuration file over OMCI
- Customer document and product support
7368 ISAM ONT G-140W-H Product Guide Configure a G-140W-H indoor ONT
Issue: 01 3FE-48054-AAAA-TCZZA 147
2 Configure the test times if desired.
3 Click Refresh to update the data.
4 STOP. This procedure is complete.
8.3 SFU mode configuration
HGU is the default mode for the G-140W-H ONT, but you can use SFU mode to view
device status information, change the password, authenticate the LOID, and change
the SLID.
8.3.1 Switch from default HGU mode to SFU mode
To switch from the default HGU mode to using SFU mode, use the procedure below.
Procedure 50 Switching to SFU mode
1 Power up the G-140W-H ONT.
2 Change the Operator ID (OPID) to XXXX to enable the ONT to switch to SFU mode, as
described in “Modifying the operator ID”.
US Packet Loss The number of upstream packages lost
DS Packet Loss The number of downstream packages lost
Internet Status Whether the broadband connections is active (UP) or not (DOWN)
Latency This test is used to determine the lowest round-trip time in milliseconds by
pinging the target server multiple times
Click Latency Test to specify the time for the test
The default is weekly, performed at idle to a public server
DNS Response Time This test is used to determine the lowest round-trip time in milliseconds by
sending a request to the target DNS server
Click DNS Response Test to specify the time for the test
The default is weekly, performed at idle to a public server
Field Description
(2 of 2)
Release 06.02.01 | September 2019 | Edition 01