Product Guide
Table Of Contents
- 7368 ISAM ONT G-140W-H Product Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI ONT safety guidelines
- 3 ETSI environmental and CRoHS guidelines
- 4 ANSI ONT safety guidelines
- 5 G-140W-H unit data sheet
- 5.1 G-140W-H part numbers and identification
- 5.2 G-140W-H general description
- 5.3 G-140W-H software and installation feature support
- 5.4 G-140W-H interfaces and interface capacity
- 5.5 G-140W-H LEDs
- 5.6 G-140W-H detailed specifications
- 5.7 G-140W-H GEM ports and T-CONTs
- 5.8 G-140W-H performance monitoring statistics
- 5.9 G-140W-H functional blocks
- 5.10 G-140W-H standards compliance
- 5.11 G-140W-H special considerations
- 6 Install a G-140W-H indoor ONT
- 7 Replace a G-140W-H indoor ONT
- 8 Configure a G-140W-H indoor ONT
- 9 ONT configuration file over OMCI
- Customer document and product support
ANSI ONT safety guidelines
42
7368 ISAM ONT G-140W-H Product Guide
3FE-48054-AAAA-TCZZA Issue: 01
4.4 Electrical safety guidelines
This section provides the electrical safety guidelines for the ONT equipment.
4.4.1 Power supplies
The use of any non-Nokia approved power supplies or power adapters is not
supported or endorsed by Nokia. Such use will void any warranty or support contract
with Nokia. Such use greatly increases the danger of damage to equipment or
property.
4.4.2 Cabling
The following are the guidelines regarding cables used for the ONT equipment:
• Use only cables approved by the relevant national electrical code.
• Use cables suitable for outdoor use for outdoor installation of ONTs.
• The ONTs have been evaluated for use with external POTS wiring without primary
protection that may not exceed 140 ft (43 m) in reach. However, the power cable
must not exceed 100 ft (31 m).
4.4.3 Protective earth
Earthing and bonding of the ONTs must comply with the requirements of NEC article
250 or local electrical codes.
4.5 ESD safety guidelines
The ONT equipment is sensitive to ESD. Operations personnel must observe the
following ESD instructions when they handle the ONT equipment.
Note — The ONTs comply with the U.S. National Electrical
Code. However, local electrical authorities have jurisdiction
when there are differences between the local and U.S.
standards.
Caution — This equipment is ESD sensitive. Proper ESD
protections should be used when entering the TELCO Access
portion of the ONT.
Release 06.02.01 | September 2019 | Edition 01