Product Guide
Table Of Contents
- 7368 ISAM ONT G-140W-H Product Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI ONT safety guidelines
- 3 ETSI environmental and CRoHS guidelines
- 4 ANSI ONT safety guidelines
- 5 G-140W-H unit data sheet
- 5.1 G-140W-H part numbers and identification
- 5.2 G-140W-H general description
- 5.3 G-140W-H software and installation feature support
- 5.4 G-140W-H interfaces and interface capacity
- 5.5 G-140W-H LEDs
- 5.6 G-140W-H detailed specifications
- 5.7 G-140W-H GEM ports and T-CONTs
- 5.8 G-140W-H performance monitoring statistics
- 5.9 G-140W-H functional blocks
- 5.10 G-140W-H standards compliance
- 5.11 G-140W-H special considerations
- 6 Install a G-140W-H indoor ONT
- 7 Replace a G-140W-H indoor ONT
- 8 Configure a G-140W-H indoor ONT
- 9 ONT configuration file over OMCI
- Customer document and product support
7368 ISAM ONT G-140W-H Product Guide G-140W-H unit data sheet
Issue: 01 3FE-48054-AAAA-TCZZA 55
Figure 15 G-140W-H indoor ONT with fiber optic connector
Table 6 describes the physical connections for G-140W-H indoor ONTs.
Table 6 G-140W-H indoor ONT physical connections
Connection
(1)
Description
POTS port This connection is provided through an RJ-11 port. One POTS connection is supported.The
POTS port supports voice services.
Ethernet ports This connection is provided through Ethernet RJ-45 connectors. Up to four 10/100/1000
Base-T Ethernet interfaces are supported.The Ethernet ports can support both data and
in-band video services on all four interfaces.
Power input This connection is provided through the power connector. A power cable fitted with a barrel
connector is used to make the connection.
Reset button Pressing the Reset button for less than 10 seconds reboots the ONT; pressing the Reset
button for 10 seconds resets the ONT to the factory defaults, except for the LOID and SLID.
WLAN button Wi-Fi service is compliant with IEEE 802.11 standards and is enabled and disabled using the
WLAN button.
WPS button The Wi-Fi Protected Setup (WPS) button enables and disables the WPS.
LED button The LED button turns the LED indicators on or off.
On/Off button This button turns the ONT on or off.
USB port This connection is provided through 2 USB ports. The ONT supports external USB hard
drives that can be made accessible to all LAN devices.
Fiber optic port The SC/APC fiber optic port is located at the back of the ONT and provides the connection
for the fiber optic cable.
Release 06.02.01 | September 2019 | Edition 01