Nokia J (BH-806) Issue 2.
Introduction About your headset With the Nokia J headset, you can handle calls hands-free, even when you are using two mobile devices at the same time. Note: The surface of this product does not contain nickel in the platings. The surface of this device contains stainless steel. Warning: This product may contain small parts. Keep them out of the reach of small children. Parts of the product are magnetic. Metallic materials may be attracted to the product.
This device is compliant with Bluetooth Specification 2.1 + EDR supporting the following profiles: Headset Profile 1.1 and Hands-Free Profile 1.5. Check with the manufacturers of other devices to determine their compatibility with this device.
5 6 Carrying clip Charger connector Start using your headset When you switch on your headset for the first time, voice prompts help you set up your headset. The headset comes with different sized earpads. Select the earpad that fits the best and is the most comfortable for your ear. To change the earpad, pull the current earpad from the earpiece, and push the new earpad into place. 1 2 3 4 To switch the headset on, remove it from the carrying clip. If the headset doesn't switch on, charge the battery.
When you unplug a charger, hold and pull the plug, not the cord. The fully charged battery has power for up to 5 hours of talk time and up to 100 hours of standby time. If you keep the headset in the carrying clip, the standby time is up to 3 months. When the battery charge is low, the red indicator light flashes, and you hear a voice prompt every 5 minutes. If you have deactivated voice prompts, the headset beeps every 5 minutes.
4 5 6 Pairing mode is activated, and a blue indicator light starts to flash quickly. Follow the voice prompts. Within 3 minutes, activate Bluetooth on the device, and set it to search for Bluetooth devices. For details, see the user guide of the device. Select the headset from the list of found devices. If required, enter the passcode 0000. You can pair your headset with 8 compatible devices, but you can only connect it to a maximum of 2 devices at the same time.
Switch a call between your headset and mobile device Touch and hold for 2 seconds. You can redial the last called number or use voice dialling, if your mobile device supports these features with the headset. Redial the last called number When no call is in progress, press . Use voice dialling When no call is in progress, press and hold in the user guide of your mobile device. for 2 seconds, and follow the instructions Change the volume Set the desired volume level on your connected mobile device.
End an ongoing call, and activate a held call Touch . If you redial or use voice dialling, the call is made on the device you last had an active call on with the headset. Settings Deactivate voice prompts Get verbal feedback and instructions, for example, when pairing your device. Make sure the headset is switched on, and touch and hold voice prompt, and a yellow indicator light flashes once. for 9 seconds. You hear a Activate voice prompts Touch and hold for 9 seconds.
This device is intended for use when supplied with power from the following chargers: AC-10, AC-6, DC-10, DC-6, DC-11, DC-11K, DT-600, and CA-146C. The exact charger model number may vary depending on the type of plug. The plug variant is identified by one of the following: E, X, AR, U, A, C, K, or B. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Talk and standby times are estimates only.
Crossed-out wheeled-bin symbol The crossed-out wheeled-bin symbol on your product, battery, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This requirement applies in the European Union. Do not dispose of these products as unsorted municipal waste. For more information on the environmental attributes of your device, see www.nokia.com/ecodeclaration.
