Operation Manual

fields can be left empty, unless your service provider
has instructed otherwise.
To use a data connection, your service provider
must support this feature, and if necessary, activate
it for your SIM card.
Packet data access points
Press , and select Tools > Settings >
Connection > Destinations > New access
point, and follow the instructions on the screen. Or,
open one of the access point groups, select an
access point marked with
, and select Edit.
Follow the instructions from your service provider.
Select from the following:
Access point name — You obtain the access
point name from your service provider.
User name — The user name may be needed to
make a data connection, and is usually provided
by the service provider.
Prompt password — If you must enter the
password every time you log in to a server, or if
you do not want to save your password in the
device, select Yes.
Password — A password may be needed to
make a data connection and is usually provided
by the service provider.
Authentication Select Secure to always send
your password encrypted or Normal to send
your password encrypted when possible.
Homepage — Depending on the access point
you are setting up, enter the web address or the
address of the multimedia message centre.
Select Options > Advanced settings and from the
following:
Network type — Select the internet protocol
type to transfer data to and from your device. The
other settings depend on the selected network
type.
Phone IP address (for IPv4 only) — Enter the IP
address of your device.
DNS addresses — Enter the IP addresses of the
primary and secondary DNS servers, if required
by your service provider. To obtain these
addresses, contact your internet service
provider.
Proxy server address — Enter the address of
the proxy server.
Proxy port number — Enter the port number
of the proxy server.
WLAN internet access points
Press , and select Tools > Settings >
Connection > Destinations > New access
point, and follow the instructions on the screen. Or,
170
Settings