Nokia Digital Pen (SU-27W) User Guide 9250690 Issue 1 EN
DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this SU-27W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/declaration_of_conformity/. © 2006 Nokia. All rights reserved. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited.
Contents 1. Introduction ......................... 4 Bluetooth wireless technology .......... 4 2. Getting started..................... 5 Chargers ................................................... 5 Open and close the USB cradle ......... 6 Charge the battery ................................ 6 Charge from a PC............................... 6 Charge from a wall outlet ............... 7 Battery level indication .................... 8 Switch the pen on or off ..................... 8 Pair the pen...........
Introduction 1. Introduction The Nokia Digital Pen allows you to write notes on compatible digital paper and transfer the notes to a compatible mobile device over a Bluetooth connection. You can also transfer the notes to a PC over a Bluetooth connection or by placing the pen in the USB cradle that is connected to the USB port of the PC. Read this user guide carefully before using the digital pen.
Getting started 2. Getting started The digital pen contains the following parts: • Pen cap (1) • Ink cartridge (2) • Battery indicator (3) • Page indicator (4) • Ink cartridge removal hole (5) • Reset button (6) 6 Before using the digital pen, you must charge its battery and pair the pen with a compatible mobile device. To use the pen with a compatible Nokia S60 or Series 80 mobile device, you must install the Nokia Digital Pen Suite software from the supplied CD-ROM to your mobile device.
Getting started For availability of approved enhancements, please check with your dealer. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord. ■ Open and close the USB cradle The pen is supplied with a USB cradle that you need when you charge the battery inside the pen. To open the USB cradle, pull the top of the cradle away from its bottom. To close the cradle, push the button on the side of the cradle.
Getting started 2. Switch on the PC, and plug the USB connector of the cradle to the USB port on the PC. 3. To start charging, remove the pen cap, and insert the pen into the USB cradle so that the connectors on the pen are facing the connectors on the cradle. If you use a laptop PC that is not plugged into a wall outlet, charging the pen battery from the PC increases the demand on the PC battery and reduces battery life.
Getting started 3. Plug the USB connector of the cradle to the AD-48 charger adapter that is supplied with the pen. 4. Plug the charger into a wall outlet, and connect the charger cable into the adapter. While the battery is charging, the battery indicator slowly flashes red, yellow, or green depending on the charge level of the battery. 5. When the battery is fully charged, the battery indicator turns green.
Getting started To switch off the pen, replace the pen cap. The battery and page indicators turn off. The pen is automatically switched off when you detach the USB cradle from the PC while the pen is placed in the cradle. To save power and protect the lens inside the pen from dirt, always keep the cap on when you are not using the pen. ■ Pair the pen You must pair the pen with a compatible mobile device to transfer data from the pen. The pen can be paired with one mobile device at a time.
Getting started In some mobile devices you may need to make the Bluetooth connection separately after pairing. You only need to pair the digital pen with your mobile device once. If the pairing is successful, the pen vibrates three times, and the page indicator turns green and is shown for 2 seconds. The pen is now ready for use. If the pairing or connection fails, the page indicator briefly flashes red twice and is shown for 2 seconds.
Getting started Only replace the ink cartridge when it is empty. Removing the cartridge can damage its tip. If you attempt to reuse a cartridge with a damaged tip, it may leak. 1. Take off the pen cap. 2. Insert the ink cartridge tip into the hole in the cap clip. 3. Tilt the cap slightly clockwise, and pull the cap clip to take out the ink cartridge. Dispose of the ink cartridge properly. 4.
Basic use 3. Basic use Note: Do not point the IR (infrared) beam at anyone's eye or allow it to interfere with other IR devices. This device is a Class 1M LED laser product. ■ Notepads The pen is delivered with two types of notepads: a small notepad (B7 size) and a large notepad (A5 size). The notepads contain digital paper that you can use with the digital pen. Use the small notepad to create short notes that you want to transfer to your mobile device over a Bluetooth connection and send as messages.
Basic use ■ Create and manage notes You can use the pen to write notes that you want save and manage with your PC or mobile device. 1. Open a large notepad that was supplied with the pen. 2. Tap the New notepad box on the first page of the notepad. 3. Write a note. You can also draw pictures. 4. To select the target device, tap the box indicated with a phone icon and a letter to transfer the note to a mobile device, or tap the box indicated with a desktop PC to download the note to a PC. 5.
Basic use of these messaging services, contact your network operator or service provider. 1. Open a small notepad that was supplied with the pen. 2. Tap the New notepad box on the first page of the notepad. 3. Ensure that the Bluetooth feature is active in your mobile device and that the pen is connected to the device. 4. Write a note that you want to transfer to your mobile device. You can also draw pictures. 5. To send the note as a small image, tap the box indicated with a large and a small phone icon.
PC connectivity 4. PC connectivity ■ Install Logitech io2 Software To use the digital pen with your PC, you need to install the Logitech io2 Software from the supplied CD-ROM. The software can be used with the Microsoft Windows XP or 2000 operating system. 1. Insert the CD-ROM in the CD drive of your PC, and follow the instructions on the screen. 2. Plug the supplied USB cradle into the USB port of your PC. 3. Take off the pen cap, and place the pen in the cradle.
Battery information 5. Battery information Your device is powered by a rechargeable battery. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with Nokia approved chargers designated for this device. Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully charged battery connected to a charger, since overcharging may shorten its lifetime.
Care and maintenance Care and maintenance Your device is a product of superior design and craftsmanship and should be treated with care. The suggestions below will help you protect your warranty coverage. • Keep all accessories and enhancements out of the reach of small children. • Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, allow it to dry completely.
