User's Manual

Basic use
15
■ Clear settings or reset
To clear your pairing, loopset volume, sidetone, and vibration mode settings
from the loopset, switch on the loopset, and press and hold the multifunction
key and the volume up key for about 5 seconds. The indicator light alternates
red, green, and blue twice, and the loopset enters pairing mode.
To reset the loopset if it stops functioning, even though it is charged,
connect the loopset to a charger while you press and hold the
multifunction key. The reset does not clear the settings.
■ Troubleshooting
If you cannot connect the loopset to your compatible device, check that
the loopset is charged, switched on, and paired with the device.
Also check that the loopset is within 10 metres (33 feet) of the device that
you have connected to it.
If you still have problems, reset the loopset. See “Clear settings or reset”,
p. 15.