User's Manual

.1 Getting Start
Before the device can be used, a pair procedure has to be carried out by switch on the slide
switch to put the device into pairing mode, and then initialize the pairing procedure on the
device and a host (PDA, Smart phone, NB PC…etc), its password is ‘0000’. After they are
paired, then the device is ready to use for normal operation. When GPS is fixed, it has
latitude, longitude, altitude, speed, course and some satellites information will be sent to
host.
.2 LEDs Function
1. Bluetooth Status LED (Blue)
Flashing - Bluetooth is on and ready to transmit.
2. GPS Status LED (Green)
Flashing - Position is fixed.
Steady light - Device is on but position is not fixed.
3. Battery Status LED (Red)
Flashing - Power is low and charging immediately is required.
Steady light - Connected to power charger, charging.
Off - Battery is fully charged and has adequate power supply.
.3 Power Connector
+5V DC power input connector
LEDs
On/Off Slide Switch
Power Connector