User's Manual

5
Copyright Nolan Systems Inc. 2005
[e-mail]
http://www.nolan-sys.com/
This material may not in whole or part be copied, or communicated to third parties without Nolan Systems prior agreement in
writing.
Nolan Systems – USA
1595 Cleo Springs Dr.
San Jose, Ca. 95131, USA
Tel: [phone] Fax: [phone]
To cancel pairing mode
While your headset is in pairing mode, you can cancel the pairing process and turn off
the headset.
Press and hold the Talk button for 4 seconds. You will hear an “OFF” tone and after
LED will quick flash 5 times, the headset is turned off. Then release the Talk button.
Making calls
You can make calls from your mobile phone, or directly from headset using voice
dialing (if it’s supported by the phone)
To make calls from your mobile phone
Dial the call from your mobile phone, and the call is automatically connected to your
Headset.
To make calls using voice dialing (if supported by your mobile phone)
1. With the headset in standby mode, press (click) he Talk button on the Headset,
and you will hear the “VD” tone.
2. Speak the name of the person you wish to call. The call is automatically
connected to your headset.
To make calls using last number redial (if supported by your mobile phone)
1. Whilst in standby mode, press and hold the Volume “-” more than 4 seconds, and you
will hear a “LND” tone (single long beep).
2. Release the Volume “-” button, the call is automatically connected to your mobile phone.
Receiving calls
You must configure your mobile phone to answer calls directly on your Bluetooth
headset. Refer to the mobile phone user guide for instructions for initiating this
feature.
When there is an incoming call, if the Headset is turned on, you can hear a “RING”
tone from headset to indicate the incoming call. Then press (click) the Talk button on
your headset. The call is automatically connected to your headset.
Reject calls
1. When your mobile phone rings, press and hold the Talk button on your headset
more than 3 seconds, and you will hear a long beep from the headset.
2. Release the Talk button.
Note: This feature can only work on the Hands-free supported phones.
Ending calls
When you want to finish your call, press (click) he Talk button on your headset. The
call will be disconnected.
Transfer calls
You can transfer the calls connected to your headset back to your mobile phone, or
from your mobile phone to your headset.