User's Manual

6
Copyright Nolan Systems Inc. 2005
[e-mail]
http://www.nolan-sys.com/
This material may not in whole or part be copied, or communicated to third parties without Nolan Systems prior agreement in
writing.
Nolan Systems – USA
1595 Cleo Springs Dr.
San Jose, Ca. 95131, USA
Tel: [phone] Fax: [phone]
To transfer calls from your headset (if phone supported)
1. With voice in headset, press and hold volume “+” button for 3 seconds on your
headset, you will hear a “CT” tone (single piping).
2. Release the Volume “+” button, and the call will transfer to your mobile phone.
To transfer calls from you mobile phone (phone dependent)
1. With voice in your mobile phone and Bluetooth connection exist, press and hold
the Volume “+” button for 4 seconds, and you will hear a Tone.
2. Release the Volume “+” button, and the call will transfer to your mobile phone.
Or
With the voice in your mobile phone and Bluetooth connection does not exist, press
the Talk button, and headset will try to connect to your phone, and voice will connect
to your headset automatically.
Or
You can also operation on your mobile phone, refer to the mobile phone user guide
for instructions for initiating this feature.
Adjust the volume
To increase the volume
While in talking mode, press (click) the Volume “+” button to increase volume by 1
step, repeat this procedure until you have reached the desired level.
To decrease the volume
While in talking mode, press (click) the Volume “-” button to decrease volume by 1
step, repeat this procedure until you have reached the desired level.
Muting headset
You can mute and un-mute the microphone temporarily so that you cannot be heard
by the connected party.
To mute the headset
With talking mode, press and hold the volume button “+” and volume button “-”
concurrently more than 3 seconds, and you will hear a MUTE tone (Single beep), the
microphone is muted.
To un-mute the headset
When microphone is muted, press and hold volume button “+” and Volume button “-”
concurrently for 3 seconds, and you will hear a MUTE tone (Single beep), the
microphone is un-muted.
Visual and audio indication
Visual indication
Two LEDs (blue and amber) indicate the status of the headset: