User's Manual

BX5
21
Con FRIENDS CONFIGURATION active:
Call CHANNEL 4 Briefly press “on”.
Call CHANNEL 5 Press the “on” key twice.
Call CHANNEL 6 Press the “on” key three times.
Disconnection of active intercom Briefly press “on”.
N.B.: In case the memory setting is empty, or the other helmet cannot be reached, an error tone will
sound in your helmet.
Taking a Bike to Bike call
Four calling tones will sound in the helmet receiving the Bike-to-Bike call, and all open audio functions
will be temporarily cut off (including the Rider – Pillion Passenger intercom, if any).
Answering a Bike to Bike phone call Briefly press any key when you hear the incoming call signal.
a. In case you take the call, communication is automatically established.
b. In case the call is not answered, the system returns to the situation prior to receiving the call.
14. “UNIVERSAL INTERCOM” INTERCOM
The N-Com M5 system can be connected via Bluetooth to intercom systems of other brands, thanks to
the UNIVERSAL INTERCOM function.
14.1. Pairing up the UNIVERSAL INTERCOM
The N-Com system can be paired up to an intercom of a different brand (from now on referred to as
Intercom B) as if it was a mobile phone.
1. Put the N-Com system in Setting Mode: press the “on” key and keep it pressed for 4 seconds,
until the red LED starts to flash quickly;
2. Put intercom B in the mobile phone pairing up mode (refer to the Intercom B manual);
3. When both systems are in the pair up mode (setting), on the N-Com system press the
command related to the “posizione di memoria” where you wish to store intercom B
(CHANNEL 1-3), see paragraph 13.2;
4. After a few seconds, Intercom B will emit the “phone connection” confirmation beep;
5. To turn on communication between the two, briefly press the “on” key on the N-Com system.
14.2. UNIVERSAL INTERCOM function
To turn on and off the audio between two helmets, proceed as follows:
From the N-Com system:
Connect or disconnect Intercom B as you would for a regular N-Com intercom (chapter 12-13)
Interco B receives a dialing one that must be answered with a phone reply command.
From an intercom of a different brand
Press the “Voice Call” command. The N-Com system receives a dialing tone; answer by pressing any key.
To disconnect the intercom, press “Voice Call” once again.