User's Manual

B901L
23
3. In the case where one of the systems presses the “N” key or falls outside the connection
range, the group intercom is interrupted.
Smart Conference connection
Press the “N” key for 2 seconds. Activation is confirmed by a
beep in the helmet and by the voice message “
Group
Intercom” .
Smart Conference disconnection
Briefly press the “N” key. Disconnection is confirmed by the
voice announcement “ Group Intercom ended .
N.B.: During a “Smart Conference” call, connection to the mobile phones of all participants is
temporarily cut off. When the conference call ends, all phones automatically reconnect to their own
intercom system.
15. “UNIVERSAL INTERCOM” INTERCOM
The N-Com B901L system can be connected via Bluetooth to intercom systems of other brands or to
N-Com systems other than the “900” series, thanks to the UNIVERSAL INTERCOM function.
Important: N-Com systems other than the “900” series must be paired up to the N-Com B901L by
following the procedure “ Pairing up the Universal Intercom ”.
Caution: Visit the www.n-com.it website for the list of compatible N-Com systems.
15.1. Pairing up the UNIVERSAL INTERCOM
The N-Com system can be paired up to the other intercom (from now on referred to as Intercom B)
as if it was a mobile phone.
1. Make sure the B901L is turned off;
2. Put the system in the “Configuration” mode: press the “ON” key and keep it pressed for 4
seconds, until the blue LED starts flashing;
3. Press the pushbutton “” until you reach the option “ Universal intercom pair up ” mode.
4. Put intercom B in the mobile phone pairing up mode (refer to the Intercom B manual);
5. After a few seconds, Intercom B will emit the “phone connection” confirmation beep;
N.B.: The system paired up using the UNIVERSAL INTERCOM is saved in the first available channel.