User's Manual

5. PAIRING UP BLUETOOTH DEVICES

In order for the Bluetooth Kit3 system to be connected to another Bluetooth device,

the latter needs to be first paired up

with the N-Com system.

The pairing up procedure is the same for all Bluetooth devices: mobile phones, MP3

Bluetooth players, satellite navigators, etc.

1. Make sure the Bluetooth Kit3 is turned off;

2. Press “on” and keep it pressed (for more than 4 seconds), until the LEDs

start to flash quickly and you hear a sharp beep in the headset, indicating

the “Pair-up mode”;

3. On the Bluetooth device, turn on the search for Bluetooth devices (refer to

the instructions manual of your device for the proper pairing up procedure,

as it varies depending on the brand and model of the device);

4. After a few seconds, the mobile phone will display the name “N-Com Bt3

v.X.XX”, followed by the manufacturer’s identification data;

5. Select the N-Com device. If a password is requested, enter 0000 (four

zeros);

6. Bluetooth Kit3 will confirm the pairing up by means of a tone in the headset,

and the LEDs will stop flashing;

7. Turn off and on both the mobile phone and the Bluetooth Kit3 to store the

pairing up data.

Note: The affiliation is stored in the helmet and in the cell phone and it is not lost

when the two devices are turned off. As a result it needs to be carried out only

once.

Note: If a Bluetooth device (mobile phone or GPS) equipped with music player with

Bluetooth A2DP player has already been paired up, the pairing up DOES NOT

have to be repeated as the A2DP protocol has already been stored in the

Bluetooth Kit3.

Once the Bluetooth device has been paired up, connection is automatic when the

system is turned on. You can nevertheless connect or disconnect from the helmet

(see the controls diagram below) or from the mobile phone.