User's Manual

4. SYSTEM CHARACTERISTICS

N-Com B1 allows wireless connection to a mobile phone, a satellite navigator, and an MP3

A2DP player using Bluetooth technology.

The system can also be used for wireless intercom communication between two helmets, if

both helmets are equipped with a N-Com Bluetooth system.

The system can be expanded by means of a USB Multimedia Wire accessory (sold

separately), which is used for cable connection to multimedia sources.

B1 can be managed, updated and customised using the “N-Com Wizard”

programme, which can be downloaded from the “Download” section of the

Internet site www.n-com.it

4.1. Basic functions

All N-Com system functions are available through the operation of three pushbuttons: “”,

“on” and “ ”. Every time the system is given a command, a special acoustic signal can be

heard, which varies depending on the function being requested. This way, all the functions

can be used while wearing the helmet.

The type of command given to the system depends on how long the pushbutton is pressed.

System ON Press “on” and keep it pressed for about 2 seconds, until the

LEDs turn on and you hear a beep in the headset.

System OFF Press “on” and keep it pressed for about 4 seconds, until the

LEDs turn off and you hear a beep in the headset.

Increase Volume Briefly press “” to increase the volume. A double tone signals

the highest volume level.

Decrease Volume Briefly press “” to decrease the volume. A double tone signals

the lowest volume level.

4.2. N-Com Wizard

“N-Com Wizard” is the PC application that can be used to manage and

configure the B1 system.

The programme can be downloaded from the Internet site www.n-com.it, in the

“Download” section. In order to use it, a helmet equipped with B1 must be connected to

the PC, using the USB cable supplied with the system.

N-Com Wizard allows you to customize your B1, specifically:

 Setting the system audio levels

 Update the device firmware

The programme includes an on-line guide that explains how it works (after installing it on

your PC, press F1 to display this guide).

5. PAIRING UP BLUETOOTH DEVICES

In order for the B1 system to be connected to another Bluetooth device, the latter needs

to be first paired up with the N-Com system.

The pairing up procedure is the same for all Bluetooth devices: mobile phones, MP3

Bluetooth players, satellite navigators, etc.

1. Make sure the B1 is turned off;