User's Manual

12
2. Press “on” and keep it pressed (for more than 6 seconds), until the LEDs start to
flash quickly and you hear a sharp beep in the headset, indicating the “Pair-up
mode”;
3. On the Bluetooth device, turn on the search for Bluetooth devices (refer to the
instructions manual of your device for the proper pairing up procedure, as it
varies depending on the brand and model of the device);
4. After a few seconds, the device will display the name “N-Com B1 v.X.XX”,
followed by the manufacturer’s identification data;
5. Select the N-Com device. If a password is requested, enter 0000 (four zeros);
6. B1 will confirm the pairing up by means of a tone in the headset, and the LEDs
will stop flashing;
7. Turn off and on both the device and the B1 to store the pairing up data.
Note: The affiliation is stored in the helmet and in the cell phone and it is not lost when
the two devices are turned off. As a result it needs to be carried out only once.
Note: If a Bluetooth device (mobile phone or GPS) equipped with music player with
Bluetooth A2DP player has already been paired up, the pairing up DOES NOT have to
be repeated as the A2DP protocol has already been stored in the B1.
Once the Bluetooth device has been paired up, connection is automatic when the system is
turned on.
5.1. Affiliation reset function
You can remove all affiliated devices from the system memory. This operation is not
reversible; right after resetting, you will have to repeat the affiliation procedure for the cell
phone (or for other compatible Bluetooth devices).
To erase all devices previously affiliated, proceed as follows:
 Press “on” and keep it pressed (for more than 4 seconds), until the LEDs start to flash
quickly and you hear a sharp beep in the headset, indicating the “Pair-up mode”;
 Press “” and “” at the same time for 4 seconds, and release them when you hear a
beep. The N-Com will emit a special acoustic signal to confirm and will then turn itself
off.
This function can also be turned on through PC using the “N-Com Wizard”
programme.
6. MOBILE PHONE FUNCTIONS
Answering a phone
call
Briefly press any key when you hear the incoming call signal
Hanging
up/rejecting a
phone call
Press “on” and keep it pressed for about 2 seconds (until you
hear the acoustic signal)
Voice call (if
equipped)
Press “on” and keep it pressed for about 2 seconds (until you
hear the acoustic signal)
Redial last number Briefly press “” and “” at the same time
Transferring a call
from helmet to
mobile phone
To transfer an ongoing call from the helmet to the mobile phone,
press both “” and “” at the same time and keep them
pressed for 4 seconds